Scribd
Upload
110 views

Power System Planning & Optimization: EEE 466 By: Desmond Okwabi Ampofo

This document discusses power system planning and optimization techniques including DC load flow analysis. It presents a power system network with two generators producing 30MW each, two loads consuming 30MW each, and several transmission lines. The document instructs the reader to use DC load flow to solve for the MW power flows on each transmission line, designating bus 3 as the slack bus.

Uploaded by

akolgo louis
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
110 views

Power System Planning & Optimization: EEE 466 By: Desmond Okwabi Ampofo

This document discusses power system planning and optimization techniques including DC load flow analysis. It presents a power system network with two generators producing 30MW each, two loads consuming 30MW each, and several transmission lines. The document instructs the reader to use DC load flow to solve for the MW power flows on each transmission line, designating bus 3 as the slack bus.

Uploaded by

akolgo louis
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 8

POWER SYSTEM PLANNING & OPTIMIZATION

EEE 466

BY: DESMOND OKWABI AMPOFO


DC load Flow
DC load Flow
DC load Flow
Transmission and distribution planning
 Solve for the MW flows for each of the transmission line shown below. Select
bus 3 as the slack bus
Transmission and distribution planning
 Solve for the MW flows for each of the transmission line shown below. Select
bus 3 as the slack bus
Transmission and distribution planning
 Consider the following power system network. Both generators are at 30MW
output and both loads are consuming 30MW. Bus 1 is the reference bus
Transmission and distribution planning
 Consider the following power system network. Both generators are at 30MW
output and both loads are consuming 30MW. Bus 1 is the reference bus

You might also like