Crown Lengthening

TARRSON FAMILY ENDOWED CHAIR IN PERIODONTICS
UCLA SCHOOL OF DENTISTRY

Presents Presents
Dr. E. Barrie Kenney
Professor & Chairman
Section of Periodontics
E. Barrie Kenney B.D.Sc., D.D.S., M.S.,
F.R.A.C.D.S.
Tarrson Family Endowed Chair in Periodontics.
Professor and Chairman Division of Associated
Clinical Specialties UCLA School of Dentistry

Surgical Techniques for
Crown Lengthening
1)Development of Adequate
Crown Preparation
2)Esthetics
Indications for Crown
Lengthening
Gingival Margins must not
invade Biological Width
Requirements for Periodontal
Health.
Development of
Adequate Crown
Preparation
There must be a minimum of
1mm between the apical level
of the Junctional Epithelium
and the bone crest.
Biological Width
Requirements
An inappropriate crown
margin increases plaque
accumulation in close
proximity to bone crest.
Crown Margins which extend
apically beyond the Junctional
Epithelium can violate the
requirements for periodontal
health.
Deeply placed crown margins
causing gingival inflammation
and pockets.
Both Central Incisors and
right lateral incisor have
crowns violating Biologic
Width concepts.
This study measured
dimensions of tissues
involved in Biological Width
considerations.
Gargiulo A., Wentz F., Orban F.
Dimensions and Relations of
the Dentogingival Junction in
Humans.
J. Periodontol 1961 32:261
These are not clinically
accurate due to distortion
with histologic processing.
Used histologic sections to
measure average dimensions
of biologic width.
This study said width of
junctional epithelium plus
connective tissue width was
Biologic width; i.e.
approximately 2 mm.

Gingival sulcus
Junctional epithelium

Connection tissue
attachment coronal
to bone
0.69 mm
0.97 mm

1.07 mm
Sulcus
depth
Biologic
Width
However since then it has
been shown that in probing
the sulcus, the probe is
generally at the deepest
position of junctional
epithelium.
If a subgingival crown margin
is placed in the middle of the
gingival sulcus, the crest of
bone should be a minimum of
2 mm apically positioned.
The necessary for 1 mm of
connective tissue between the
epithelium and bone is a
minimal requirement. Larger
dimensions can be compatible
with healthy tissues.
When a subgingival crown
margin is to be placed it may
be necessary to surgically
move the crestal bone margin
apically so that there is at
least 2 mm space between
the margin and the bone.
This is the method of choice
when crown margins will
impinge on the Biologic
Width.
Use of Flap Surgery with
Osseous Resection
Periapical Radiographs are
needed to ensure sufficient root
length is available. This case
cannot have surgical crown
lengthening and both premolars
need to be extracted.
This patient had extensive
tooth wear and loss of Vertical
Dimension
There was insufficient clinical
crown volume of the incisors for
adequate retention so flap
surgery was indicated.
Prior to Flap Surgery
Full thickness labial and lingual
flaps .
Bone is recontoured so that 2
mm distance between level of
proposed crown margin and
crest of bone.
The lingual side required
minimal bone surgery.
Flaps are positioned apically to
increase length of clinical
crowns.
Similar apical positioning on
Lingual.
Crown preparations 12 weeks
after crown lengthening
surgery.
Final upper and lower
restorations.
After Before
Inadequate clinical crowns for
retention of new restorations.
Flap design on buccal.
Intrasulcular incisions, mesial
vertical incision, distal wedge.
Flap design on palatal. Reverse
bevel incision removing gingival
margin ,mesial vertical incision,
distal wedge.
Buccal full thickness flap
elevation to expose at least 3
mm of crestal bone.
Palatal flap elevation to expose
at least 3 mm of crestal bone.
The gingival level of new crown
margin is estimated and bone
removed so crestal level is 2
mm apical to this.
Buccal crown margins will be
subgingival for esthetics. So
margins will be in middle of
gingival sulcus i.e. 1 mm
coronal to probing depth, add
another 1 mm for connective
tissue to determine bone level.
Palatal crown margin will be
supragingival. So allow 1mm
for connective tissue plus 2 to 3
mm for sulcus with bone level 3
to 4 mm apical to level of crown
margin.
Buccal flap sutured apically with
increased tooth structure for
crown preparation.
Palatal flap repositioned with
continuous sling mattress
sutures and simple U shaped
sutures of distal wedge and
vertical incisions.
Buccal Healing at 3 weeks.
Palatal Healing at 3 weeks.
Crowns placed at 6 weeks.
After Before
After Before
Most cases need flap and
osseous surgery.
Gingivectomy used when have
adequate band of Keratinized
tissue and bone crest is
positioned apically with an
initial wide Biological Width.
Gingivectomy for Crown
Lengthening
Poor crowns with recurrent
caries.
Soft tissue removal will be
adequate for exposure of sound
tooth for margins with a 1 mm
Ferrule Extension.
Electrosurgery used for
gingivectomy. This can also be
done with scalpels or laser.
Tissue recontoured to expose
root surfaces for adequate
preparation of margins.
Provisional restorations at 12
weeks. Marginal gingiva is now
stable so final subgingival
crowns can be completed.
In esthetic areas a minimum
of 12 weeks after-surgery is
required to be sure no further
gingival recession will occur.
Final crown restorations
should not be completed until
a minimum of 6 weeks after
surgery in order to minimized
further tissue loss due to
trauma of impressions.

Crown Lengthening

Uploaded by

Copyright:

Available Formats

Crown Lengthening

Uploaded by

Document Information

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Crown Lengthening

Uploaded by

Copyright:

Available Formats

TARRSON FAMILY ENDOWED CHAIR IN PERIODONTICS

UCLA SCHOOL OF DENTISTRY

You might also like