Scribd
Upload
2 views

Module 3

Uploaded by

mohammed.wessam0911
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
2 views

Module 3

Uploaded by

mohammed.wessam0911
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1

/*

Write a program that causes the built-in LED connected to pin 13 on the Arduino
to blink,
alternating between fast blinks and slow blinks. The LED should blink 5 times,
once every half second, and then it should blink 5 more times, once every two
seconds.
The LED should continue to blink in this alternating fashion for as long as the
Arduino receives power.
*/
int led = 13;
int i=0;
// the setup routine runs once when you press reset:
void setup() {
// initialize the digital pin as an output.
pinMode(led, OUTPUT);
}
// the loop routine runs over and over again forever:
void loop()
{
for (i=1;i<=5;i++)
{
digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level)
delay(500); // wait for a second
digitalWrite(led, LOW); // turn the LED off by making the voltage LOW
delay(500); // wait for a second
}
for (i=1;i<=5;i++)
{
digitalWrite(led, HIGH); // turn the LED on (HIGH is the voltage level)
delay(2000); // wait for a second
digitalWrite(led, LOW); // turn the LED off by making the voltage LOW
delay(2000); // wait for a second
} // wait for a second
}

You might also like