Scribd
Upload
95 views

LED Arduino

The document initializes 12 digital pins from 2 to 13 to control LEDs. It sets the pins as outputs in setup() and then uses loop() to turn each LED on for 1 second, then off for 1 second by writing high and low voltages, cycling through all 12 LEDs. This causes all 12 LEDs to blink on and off sequentially.

Uploaded by

Calvin Janapin
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
95 views

LED Arduino

The document initializes 12 digital pins from 2 to 13 to control LEDs. It sets the pins as outputs in setup() and then uses loop() to turn each LED on for 1 second, then off for 1 second by writing high and low voltages, cycling through all 12 LEDs. This causes all 12 LEDs to blink on and off sequentially.

Uploaded by

Calvin Janapin
Copyright
© © All Rights Reserved
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 2

//initializing a variable pin 2 to 13

int led1 = 2;
int led2 = 3;
int led3 = 4;
int led4 = 5;
int led5 = 6;
int led6 = 7;
int led7 = 8;
int led8 = 9;
int led9 = 10;
int led10 = 11;
int led11 = 12;
int led12 = 13;

void setup() {
//put your setup code here, to run once:
//initialize digital pin as output
pinMode(led1, OUTPUT);
pinMode(led2, OUTPUT);
pinMode(led3, OUTPUT);
pinMode(led4, OUTPUT);
pinMode(led5, OUTPUT);
pinMode(led6, OUTPUT);
pinMode(led7, OUTPUT);
pinMode(led8, OUTPUT);
pinMode(led9, OUTPUT);
pinMode(led10, OUTPUT);
pinMode(led11, OUTPUT);
pinMode(led12, OUTPUT);
}

void loop() {
// put your main code here, to run repeatedly:
digitalWrite(led1, HIGH);//it mean to give 5v (high) to pins.here ,the led will be
on.
delay(1000);//1000 = 1 second
digitalWrite(led2, HIGH);
delay(1000);
digitalWrite(led3, HIGH);
delay(1000);
digitalWrite(led4, HIGH);
delay(1000);
digitalWrite(led5, HIGH);
delay(1000);
digitalWrite(led6, HIGH);
delay(1000);
digitalWrite(led7, HIGH);
delay(1000);
digitalWrite(led8, HIGH);
delay(1000);
digitalWrite(led9, HIGH);
delay(1000);
digitalWrite(led10, HIGH);
delay(1000);
digitalWrite(led11, HIGH);
delay(1000);
digitalWrite(led12, HIGH);
delay(1000);
digitalWrite(led1, LOW);//it mean to give 0v, low to pin.here, led will be off
delay(1000);
digitalWrite(led2, LOW);
delay(1000);
digitalWrite(led3, LOW);
delay(1000);
digitalWrite(led4, LOW);
delay(1000);
digitalWrite(led5, LOW);
delay(1000);
digitalWrite(led6, LOW);
delay(1000);
digitalWrite(led7, LOW);
delay(1000);
digitalWrite(led8, LOW);
delay(1000);
digitalWrite(led9, LOW);
delay(1000);
digitalWrite(led10, LOW);
delay(1000);
digitalWrite(led11, LOW);
delay(1000);
digitalWrite(led12, LOW);
delay(1000);
}

You might also like