Scribd
Upload
48 views

Assignment 1 2020

This document provides instructions for Assignment 1 of the MMB 231 Engineering and Computer Aided Drafting course at the University of Botswana's Faculty of Engineering & Technology. Students are to individually submit by September 22, 2020 technical drawings of a bevel gear support and shaft bracket from diagrams provided. For each diagram, students must create specific orthographic views in either first or third angle projection, including a sectional view, side view, top view, and title block. All drawings must be fully dimensioned for accurate marking.

Uploaded by

Nɩʜɩɭɩstic Ucʜɩʜʌ Sʌsʋĸɘ
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
48 views

Assignment 1 2020

This document provides instructions for Assignment 1 of the MMB 231 Engineering and Computer Aided Drafting course at the University of Botswana's Faculty of Engineering & Technology. Students are to individually submit by September 22, 2020 technical drawings of a bevel gear support and shaft bracket from diagrams provided. For each diagram, students must create specific orthographic views in either first or third angle projection, including a sectional view, side view, top view, and title block. All drawings must be fully dimensioned for accurate marking.

Uploaded by

Nɩʜɩɭɩstic Ucʜɩʜʌ Sʌsʋĸɘ
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

UNIVERSITY OF BOTSWANA

FACULTY OF ENGINEERING & TECHNOLOGY (FET)


MMB 231: ENGINEERING AND COMPUTER AIDED DRAFTING

Assignment 1 2020

Instructions: Work individually and submit by Tuesday 22 September 2020

Figures 1 and 2 below represent a bevel gear support and a shaft bracket respectively. Study
the diagrams carefully and answer the questions that follow. Use appropriate scale where
deemed necessary, and approximate dimensions where not indicated.

1. For figure 1;

Draw the following views in third angle projection:


a) A sectional front view on a plane through A-A. 13 Marks
b) A side view from B. 13 Marks
c) A top view. 13 Marks
d) Provide a title block. 5 Marks
e) Dimension your drawing fully. 6 Marks

2. For figure 2;

Draw the following views in first angle projection:


a) A front view from A. 13 Marks
b) A sectional side view from B on the centre line. 13 Marks
c) A top view. 13 Marks
d) Provide a title block. 5 Marks
e) Dimension your drawing fully. 6 Marks

Page 1of 1
Figure 1: Bevel gear support.

Page 2of 1
Figure 2: Shaft bracket.

Page 3of 1

You might also like