Scribd
Upload
158 views2 pages

Tutorial 2 - Orthographic Projections

This document provides instructions for Tutorial 2 on orthographic projections. Students are asked to draw three orthographic views and dimensions for two blocks in different projection styles and a bracket with specified views. They are also to draw a full sectional view of the bracket with a cutting plane passing through the center and viewed in the direction indicated by an arrow. The tutorial is worth a total of 38 + 38 + 12 = 88 marks.

Uploaded by

Nɩʜɩɭɩstic Ucʜɩʜʌ Sʌsʋĸɘ
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
158 views2 pages

Tutorial 2 - Orthographic Projections

This document provides instructions for Tutorial 2 on orthographic projections. Students are asked to draw three orthographic views and dimensions for two blocks in different projection styles and a bracket with specified views. They are also to draw a full sectional view of the bracket with a cutting plane passing through the center and viewed in the direction indicated by an arrow. The tutorial is worth a total of 38 + 38 + 12 = 88 marks.

Uploaded by

Nɩʜɩɭɩstic Ucʜɩʜʌ Sʌsʋĸɘ
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

UNIVERSITY OF BOTSWANA

FACULTY OF ENGINEERING & TECHNOLOGY (FET)


MMB 231: ENGINEERING AND COMPUTER AIDED DRAWING

Tutorial 2: Orthographic Projections

1. The figures (a) and (b) below are isometric drawings of simple blocks. Using a scale of 1:1,
draw three orthographic views (front view (A), right-end view (B) and plan (top view) of
the components:
i. block (a) in first angle projection.
ii. block (b) in third angle projection.
Dimension your drawings fully. [38 Marks]

(a) (b)

Page 1of 2
2. The figure below is an isometric drawing of a bracket. Using a scale of 1:1, draw three
orthographic views (front view, top view and left-end view) of the component in first angle
projection. The front view must be taken in the direction of arrow A and left-end view in
the direction of arrow B. Dimension your drawings fully. [38 Marks]

3. Draw a full sectional view of the drawing with the cutting plane passing through the centre
of the component, and viewed normally in the direction of arrow A as shown. Dimension
your drawing fully. [12 Marks]

Page 2of 2

You might also like