E70 Running Board Install
E70 Running Board Install
E70 Running Board Install
Installation Instructions.
Aluminium Running boards retrofit kit
BMW X5 Series (E 70)
Retrofit kit No. 51 71 0 421 781 Aluminium running boards retrofit kit
Installation time
The installation time for the aluminium running boards retrofit is approx. 2 hours.
The installation time may vary depending on condition of the car and the equipment in it.
Important information
These installation instructions are primarily designed for use within the BMW dealership organisation and by
authorised BMW service companies.
In any event, the target group for these installation instructions is specialist personnel trained on BMW cars with
the appropriate specialist knowledge.
All work must be completed using the latest BMW repair manuals, circuit diagrams, servicing manuals and work
instructions, in a rational order, using the prescribed tools (special tools) and observing current health and safety
regulations.
If you experience installation or function problems, limit troubleshooting to approx. 0.5 hour for
mechanical or 1.0 hour for electrical work.
In order to reduce costs and avoid any additional expense, send a query immediately to the Technical Parts Support
via the Aftersales Assistance Portal (ASAP).
Please provide the following information:
- Chassis number
- Part number of the retrofit kit
- A precise description of the problem
- Work steps already carried out
Do not archive the hard copy of these installation instructions since daily updates are made by ASAP.
Installation information
All pictures show LHD cars; proceed accordingly on RHD cars.
Section Page
1. Parts list . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Legende
Step 1
Release expander rivets (1) on wheel arch trim at
rear.
Detach trim (2) at clip (3).
Release screws (4).
Installation:
Replace expander rivets (1).
If necessary, replace faulty clip (3).
Step 2
Release clips (1) and screw (2).
Installation:
If necessary, replace faulty clip (1).
Fit clips (1) with O-rings.
Step 3
Unclip panel (1) in area (A).
Open doors, detach panel (1) at clips (2) and remo-
ve in direction of arrow.
Installation:
If necessary, replace faulty clip (2).
Fit clips (2) with O-rings.
Step 4
Installation:
Inspect catches (1) on holder (2) these must not be
damaged.
Step 5
Release screws (1 und 2).
Remove support part (3).
Tightening torque 51 71 6AZ.
Important: Sealer must be applied around the
fixing holes before mounting the running
board to the vehicle. Please see pages 6 and
7 for this important step.
Step 6
Fix running board (3) with screws (2) and mount
clips (1) .
Step 7
Installation:
Make sure inserts (1) are correctly seated.
Finish the assembly of the sill covers with the
running boards by using steps 1 to 3 in re-
verse order.
Method
- Clean the surface, apply windshield adhesive into and around the
8 centre fixing holes (marked red above).
- Insert screws and tighten per normal process.
10/2007
- Same applies for left and right sides.
(T/T)
6
© BMW AG, Munich
Method
- Clean the surface, apply windshield adhesive into and around the fixing holes (marked red above).
The aim is to seal the small gaps between the body panels and the nut.
10/2007