Marine Navigation Lighting and Control Systems
Marine Navigation Lighting and Control Systems
Marine Navigation Lighting and Control Systems
MASTHEAD
The Oxley Masthead Light not only meets the requirements of the
COLREGS for vessels of over 50m as a stand alone part, but the LED
light source also provides the advantage of low power consumption.
SIDE LIGHT
The critical COLREG angular cut-off requirements are met entirely
within the housing of the Oxley sidelights, removing the need for
fitted sidescreens. All other requirements of the COLREGs for vessels
over 50m are met with the added advantages provided by LED light
sources. LEDs are carefully binned to guarantee lifetime compliance
to the regulations.
ANCHOR
The position of the LEDs in the Oxley anchor light have been calculated
to provide an even light output over the full required 360°. They are
carefully binned to confirm full compliance to the COLREGs over the
lifetime of the product.
NUC/RAM/CBD
These lights have been designed to meet all the signalling requirements
detailed in the COLREGs for vessels over 50m in length. The Oxley
NUC/RAM/CBD Lights are designed to be used in tandem with one light
mounted in front of the mast and a second mounted to the rear with the
required 360° distribution split between the two. The lights are available
in red only or red/white with the red modes able to flash in order to cover
all possible signalling variations required by the COLREGs.
225 OR
DC AFT LIGHT (RED) RED DC 18-32VDC Y 3
140
225 OR
DC FORE LIGHT (RED) RED DC 18-32VDC Y 3
140
RED/ 225 OR
DC AFT LIGHT (RED/WHITE) DC 18-32VDC Y 3
WHITE 140
RED/ 225 OR
DC FORE LIGHT (RED/WHITE) DC 18-32VDC Y 3
WHITE 140
OTHER LIGHTS
Oxley also provides a selection of subsidury lights which are also
suitable for vessels of 50m or more in length but may be implemented
at the users discretion. These include Masthead and Hull Contour
lights which provide outline information for those viewing the vessel.
The Hull Contour Light is intended to be mounted in an inverted
position pointing at the hull. An LED optic provides a light output
specifically designed to give an even distribution over the surface.
The Manoeuvring and Warning Signal Light is designed to meet the
requirements of the optional visual signalling as prescribed in Rule 34
of the COLREGs.
MANOEUVRING AND
WHITE 180 DC 18-32VDC Y 5
WARNING SIGNAL LIGHT
ACCESSORIES
An optional bird spike is available to fit onto all variants of the range.
Series 2
Oxley also offers a Series 2 range of Navigation Lights, this suite offers all
of the features of the Series 1 range with additional benefits. The series 2
lights have the option to be stacked on top of one another, this is ideal for
use as a primary and backup light. The units are fitted with a heater that
comes on at low temperatures to prevent ice accumulation on the lens,
suitable for use in artic conditions. The lights have a long life of 30,000
hours minimum.
Note: Series 2 lights are fitted with a cable rather than with a 38999 connector as used by Series 1.
ANCHOR
DESCRIPTION COLOUR ANGLE VOLTAGE/RANGE DIMMING VISIBILITY (NM)
MASTHEAD
DESCRIPTION COLOUR ANGLE VOLTAGE/RANGE DIMMING VISIBILITY (NM)
PORT LIGHT
DESCRIPTION COLOUR ANGLE VOLTAGE/RANGE DIMMING VISIBILITY (NM)
STERN
DESCRIPTION COLOUR ANGLE VOLTAGE/RANGE DIMMING VISIBILITY (NM)
OTHER LIGHTS
DESCRIPTION COLOUR ANGLE VOLTAGE/RANGE DIMMING VISIBILITY (NM)
INSTALLATION SERVICE
A full turnkey installation and commissioning package can be offered through our experienced
marine electrical installation team.
All engineers & project managers are fully qualified, have UK security clearance, able to travel
worldwide and are experienced in working in commercial and military shipyards and sailing with
ships on sea trials or support where required.
EFL Light
Gooseneck Light