Cambridge IGCSE™

PHYSICS 0625/52
Paper 5 Practical October/November 2020
MARK SCHEME
Maximum Mark: 40

Published

This mark scheme is published as an aid to teachers and candidates, to indicate the requirements of the
examination. It shows the basis on which Examiners were instructed to award marks. It does not indicate the
details of the discussions that took place at an Examiners’ meeting before marking began, which would have
considered the acceptability of alternative answers.

Mark schemes should be read in conjunction with the question paper and the Principal Examiner Report for
Teachers.

Cambridge International will not enter into discussions about these mark schemes.

Cambridge International is publishing the mark schemes for the October/November 2020 series for most
Cambridge IGCSE™, Cambridge International A and AS Level and Cambridge Pre-U components, and some
Cambridge O Level components.

This document consists of 8 printed pages.

© UCLES 2020 [Turn over

0625/52 Cambridge IGCSE – Mark Scheme October/November 2020
PUBLISHED
Generic Marking Principles

These general marking principles must be applied by all examiners when marking candidate answers. They should be applied alongside the
specific content of the mark scheme or generic level descriptors for a question. Each question paper and mark scheme will also comply with these
marking principles.

GENERIC MARKING PRINCIPLE 1:

Marks must be awarded in line with:

• the specific content of the mark scheme or the generic level descriptors for the question
• the specific skills defined in the mark scheme or in the generic level descriptors for the question
• the standard of response required by a candidate as exemplified by the standardisation scripts.

GENERIC MARKING PRINCIPLE 2:

Marks awarded are always whole marks (not half marks, or other fractions).

GENERIC MARKING PRINCIPLE 3:

Marks must be awarded positively:

• marks are awarded for correct/valid answers, as defined in the mark scheme. However, credit is given for valid answers which go beyond the
scope of the syllabus and mark scheme, referring to your Team Leader as appropriate
• marks are awarded when candidates clearly demonstrate what they know and can do
• marks are not deducted for errors
• marks are not deducted for omissions
• answers should only be judged on the quality of spelling, punctuation and grammar when these features are specifically assessed by the
question as indicated by the mark scheme. The meaning, however, should be unambiguous.

GENERIC MARKING PRINCIPLE 4:

Rules must be applied consistently, e.g. in situations where candidates have not followed instructions or in the application of generic level
descriptors.

© UCLES 2020 Page 2 of 8

0625/52 Cambridge IGCSE – Mark Scheme October/November 2020
PUBLISHED
GENERIC MARKING PRINCIPLE 5:

Marks should be awarded using the full range of marks defined in the mark scheme for the question (however; the use of the full mark range may
be limited according to the quality of the candidate responses seen).

GENERIC MARKING PRINCIPLE 6:

Marks awarded are based solely on the requirements as defined in the mark scheme. Marks should not be awarded with grade thresholds or
grade descriptors in mind.

Science-Specific Marking Principles

1 Examiners should consider the context and scientific use of any keywords when awarding marks. Although keywords may be present, marks
should not be awarded if the keywords are used incorrectly.

2 The examiner should not choose between contradictory statements given in the same question part, and credit should not be awarded for any
correct statement that is contradicted within the same question part. Wrong science that is irrelevant to the question should be ignored.

3 Although spellings do not have to be correct, spellings of syllabus terms must allow for clear and unambiguous separation from other syllabus
terms with which they may be confused (e.g. ethane / ethene, glucagon / glycogen, refraction / reflection).

4 The error carried forward (ecf) principle should be applied, where appropriate. If an incorrect answer is subsequently used in a scientifically
correct way, the candidate should be awarded these subsequent marking points. Further guidance will be included in the mark scheme where
necessary and any exceptions to this general principle will be noted.

5 ‘List rule’ guidance

For questions that require n responses (e.g. State two reasons …):

• The response should be read as continuous prose, even when numbered answer spaces are provided.
• Any response marked ignore in the mark scheme should not count towards n.
• Incorrect responses should not be awarded credit but will still count towards n.
• Read the entire response to check for any responses that contradict those that would otherwise be credited. Credit should not be
awarded for any responses that are contradicted within the rest of the response. Where two responses contradict one another, this should
be treated as a single incorrect response.
• Non-contradictory responses after the first n responses may be ignored even if they include incorrect science.

© UCLES 2020 Page 3 of 8

0625/52 Cambridge IGCSE – Mark Scheme October/November 2020
PUBLISHED
6 Calculation specific guidance

Correct answers to calculations should be given full credit even if there is no working or incorrect working, unless the question states ‘show
your working’.

For questions in which the number of significant figures required is not stated, credit should be awarded for correct answers when rounded by
the examiner to the number of significant figures given in the mark scheme. This may not apply to measured values.

For answers given in standard form (e.g. a × 10n) in which the convention of restricting the value of the coefficient (a) to a value between 1
and 10 is not followed, credit may still be awarded if the answer can be converted to the answer given in the mark scheme.

Unless a separate mark is given for a unit, a missing or incorrect unit will normally mean that the final calculation mark is not awarded.
Exceptions to this general principle will be noted in the mark scheme.

7 Guidance for chemical equations

Multiples / fractions of coefficients used in chemical equations are acceptable unless stated otherwise in the mark scheme.

State symbols given in an equation should be ignored unless asked for in the question or stated otherwise in the mark scheme.

© UCLES 2020 Page 4 of 8

0625/52 Cambridge IGCSE – Mark Scheme October/November 2020
PUBLISHED
Question Answer Marks

1(a)(i) L value in mm 1

1(a)(ii) clear diagram showing horizontal line of set square across to metre rule 1

1(b) l values increasing 1

all > L 1

1(c) graph: 1

axes correctly labelled and right way round

suitable scales 1

all plots correct to ½ small square 1

good line judgement, thin, continuous line 1

1(d) intercept method clearly shown 1

l0 value correctly read to ½ small square 1

1(e) L – l0 = 0 ± 2 mm 1

© UCLES 2020 Page 5 of 8

0625/52 Cambridge IGCSE – Mark Scheme October/November 2020
PUBLISHED
Question Answer Marks

2(a) normal in centre of AB to 2 mm and at 90° 1

F and G correctly labelled

2(b)(i) P1P2 pin separation at least 5.0 cm 1

all lines in approximately correct positions and neat 1

2(b)(ii) a correct to ± 1 mm 1

2(b)(iii) b correct to ± 1 mm 1

2(c) candidate’s θ correct to ± 2(°) 1

θ = 30 ± 2° unit needed 1

2(d) any one from: 1

thin lines / thin pins / sharp pencil
view bases of pins
ensure pins vertical / perpendicular to ray trace sheet
use large pin separation
(securely) attach the ray trace sheet to the surface

2(e) maximum range 27(°) – 33(°) 1

2(f) repeat experiment using more i values 1

uses at least 4 i values 1

© UCLES 2020 Page 6 of 8

0625/52 Cambridge IGCSE – Mark Scheme October/November 2020
PUBLISHED
Question Answer Marks

3(a)(i) I to at least 2 decimal places and < 1 A 1

3(a)(ii) V1 to at least 1 decimal place and < 3 V 1

R1 correct 1

3(a)(iii) V2 present, R2 correct and units V and A 1

3(a)(iv) V3 present, R3 present and to 2 or 3 significant figures 1

Unit Ω 1

R1 = 3 × R3 to within 10% 1

3(b)(i) expect second box ticked 1

3(b)(ii) correct justification using results 1

3(c) use different lengths (of the wire sample) 1

measure the p.d. and current / determine the resistance (of each length) 1

© UCLES 2020 Page 7 of 8

0625/52 Cambridge IGCSE – Mark Scheme October/November 2020
PUBLISHED
Question Answer Marks

4 MP1 Apparatus: 1

method of heating water and timer

MP2 Method: 1

measure the temperature of the water and place the ice cube(s) in the water and measure the time taken to melt

MP3 repeat with water at different temperature(s) 1

MP4, MP5 Key variables: 2

Any two from:

mass / volume of ice cubes
number / size of ice cubes (per test)
temperature of ice cubes / keep ice cubes in a freezer
room temperature
volume of water in the beaker
amount of stirring

MP6 Table: 1

table with columns for time / t and water temperature with correct units

MP7 Conclusion: 1

explanation of how to reach a conclusion

Additional graph notes:

NOTE: The principle to apply here is ‘could I draw a significantly better line, using these points, under examination conditions?’ If the answer is
definitely ‘yes’, do not award the mark.
NOTE: If candidate’s scale consists of actual readings at equal intervals this will produce a perfect straight line! The only mark available in this case
is the first (axes right way round and labelled) So maximum 1.
– If axes are wrong way round, the other 3 marks are still available.

© UCLES 2020 Page 8 of 8