Talk:Wire gauge

Electronics Low‑importance

	Electronics portal This article is part of WikiProject Electronics, an attempt to provide a standard approach to writing articles about electronics on Wikipedia. If you would like to participate, you can choose to edit the article attached to this page, or visit the project page, where you can join the project and see a list of open tasks. Leave messages at the project talk pageElectronicsWikipedia:WikiProject ElectronicsTemplate:WikiProject Electronicselectronic articles
Low	This article has been rated as Low-importance on the project's importance scale.

Engineering Low‑importance

	Engineering portal This article is within the scope of WikiProject Engineering, a collaborative effort to improve the coverage of engineering on Wikipedia. If you would like to participate, please visit the project page, where you can join the discussion and see a list of open tasks.EngineeringWikipedia:WikiProject EngineeringTemplate:WikiProject EngineeringEngineering articles
Low	This article has been rated as Low-importance on the project's importance scale.

I believe this page needs to link to a page with a list of what current is safe for a gauge, near the sentence "This determines the amount of electrical current a wire can safely carry". (69.5.154.26 05:09, 29 April 2007 (UTC))[reply]

Stranded wire

How is the guage of multi-strand wire determined? Does it just just depend on the outside diameter of the wire, or is there some compensation for the fact that there are air gaps between the strands? --Ong saluri (talk) 06:49, 9 March 2009 (UTC)[reply]

The gauge number is the number of the solid wire with the equivalent total cross-section; for instance, a solid 4/0 AWG wire has a diameter of 0.46 inches but a 19-strand 4/0 wire has an overall diameter of 0.528 inches, according to ASTM standard B8. --Wtshymanski (talk) 13:41, 9 March 2009 (UTC)[reply]

History of Wire Gauge

Can anyone add to the article how (mathematical conversion from standard units) the wire gauge was/is derived? Like how does a smaller gauge correspond to a fatter wire? This question may be pertinent to gauges in general, which are units of measurement that are not specific to electrical wiring, such as bore diameter of shotguns, etc.--2600:6C48:7006:200:D84D:5A80:173:901D (talk) 01:50, 20 December 2017 (UTC)[reply]

Suggest you re-read the article. Eric ^talk 02:04, 20 December 2017 (UTC)[reply]

Standard for measuring Wire Gauge

Given that manufacturers like to shave every penny on the cost of things (including electrical wire) is there an accepted standard for measuring wire gauge? Consider that stranded wire (whatever its design) is different than solid wire also, and that metallurgy is not consistent. Please contribute more information to this article. --2600:6C48:7006:200:D84D:5A80:173:901D (talk) 01:49, 20 December 2017 (UTC)[reply]

Did you read the whole article? Eric ^talk 02:05, 20 December 2017 (UTC)[reply]

A Commons file used on this page or its Wikidata item has been nominated for deletion

The following Wikimedia Commons file used on this page or its Wikidata item has been nominated for deletion:

Gauge Chart.pdf

Participate in the deletion discussion at the nomination page. —Community Tech bot (talk) 21:37, 12 July 2022 (UTC)[reply]