CPU Scheduling

 Basic Concepts
 Scheduling Criteria
 Scheduling Algorithms
 Multiple-Processor Scheduling
 Real-Time Scheduling
 Algorithm Evaluation

Operating System Concepts 6.1 Silberschatz, Galvin and Gagne 2002

 Basic Concepts

 Maximum CPU utilization obtained with

multiprogramming
 CPU–I/O Burst Cycle – Process execution consists of a
cycle of CPU execution and I/O wait.
 CPU burst distribution

Operating System Concepts 6.2 Silberschatz, Galvin and Gagne 2002

 Alternating Sequence of CPU And I/O Bursts

Operating System Concepts 6.3 Silberschatz, Galvin and Gagne 2002

 Histogram of CPU-burst Times

Operating System Concepts 6.4 Silberschatz, Galvin and Gagne 2002

 CPU Scheduler

 Selects from among the processes in memory that are

ready to execute, and allocates the CPU to one of them.
 CPU scheduling decisions may take place when a
process:
1. Switches from running to waiting state.
2. Switches from running to ready state.
3. Switches from waiting to ready.
4. Terminates.
 Scheduling under 1 and 4 is nonpreemptive.
 All other scheduling is preemptive.

Operating System Concepts 6.5 Silberschatz, Galvin and Gagne 2002

 Dispatcher

 Dispatcher module gives control of the CPU to the

process selected by the short-term scheduler; this
involves:
 switching context
 switching to user mode
 jumping to the proper location in the user program to restart
that program
 Dispatch latency – time it takes for the dispatcher to stop
one process and start another running.

Operating System Concepts 6.6 Silberschatz, Galvin and Gagne 2002

 Scheduling Criteria

 CPU utilization – keep the CPU as busy as possible

 Throughput – # of processes that complete their
execution per time unit
 Turnaround time – amount of time to execute a particular
process
 Waiting time – amount of time a process has been
waiting in the ready queue
 Response time – amount of time it takes from when a
request was submitted until the first response is
produced, not output (for time-sharing environment)

Operating System Concepts 6.7 Silberschatz, Galvin and Gagne 2002

 Optimization Criteria

 Max CPU utilization

 Max throughput
 Min turnaround time
 Min waiting time
 Min response time

Operating System Concepts 6.8 Silberschatz, Galvin and Gagne 2002

 First-Come, First-Served (FCFS) Scheduling

Process Burst Time

P1 24
P2 3
P3 3
 Suppose that the processes arrive in the order: P1 , P2 , P3
The Gantt Chart for the schedule is:

P1 P2 P3

0 24 27 30
 Waiting time for P1 = 0; P2 = 24; P3 = 27
 Average waiting time: (0 + 24 + 27)/3 = 17

Operating System Concepts 6.9 Silberschatz, Galvin and Gagne 2002

 FCFS Scheduling (Cont.)

Suppose that the processes arrive in the order

P2 , P3 , P1 .
 The Gantt chart for the schedule is:

P2 P3 P1

0 3 6 30

 Waiting time for P1 = 6; P2 = 0; P3 = 3

 Average waiting time: (6 + 0 + 3)/3 = 3
 Much better than previous case.
 Convoy effect short process behind long process

Operating System Concepts 6.10 Silberschatz, Galvin and Gagne 2002

 Shortest-Job-First (SJR) Scheduling

 Associate with each process the length of its next CPU

burst. Use these lengths to schedule the process with
the shortest time.
 Two schemes:
 nonpreemptive – once CPU given to the process it cannot
be preempted until completes its CPU burst.
 preemptive – if a new process arrives with CPU burst length
less than remaining time of current executing process,
preempt. This scheme is know as the
Shortest-Remaining-Time-First (SRTF).
 SJF is optimal – gives minimum average waiting time for
a given set of processes.

Operating System Concepts 6.11 Silberschatz, Galvin and Gagne 2002

 Example of Non-Preemptive SJF

Process Arrival Time Burst Time

P1 0.0 7
P2 2.0 4
P3 4.0 1
P4 5.0 4
 SJF (non-preemptive)
P1 P3 P2 P4

0 3 7 8 12 16

 Average waiting time = (0 + 6 + 3 + 7)/4 - 4

Operating System Concepts 6.12 Silberschatz, Galvin and Gagne 2002

 Example of Preemptive SJF

Process Arrival Time Burst Time

P1 0.0 7
P2 2.0 4
P3 4.0 1
P4 5.0 4
 SJF (preemptive)

P1 P2 P3 P2 P4 P1

0 2 4 5 7 11 16

 Average waiting time = (9 + 1 + 0 +2)/4 - 3

Operating System Concepts 6.13 Silberschatz, Galvin and Gagne 2002

 Determining Length of Next CPU Burst

 Can only estimate the length.

 Can be done by using the length of previous CPU bursts,
using exponential averaging.

1. tn actual lenght of nthCPU burst

2.  n 1 predicted value for the next CPU burst
3.  , 0  1
4. Define :

 n 1  tn  1    n .

Operating System Concepts 6.14 Silberschatz, Galvin and Gagne 2002

 Prediction of the Length of the Next CPU Burst

Operating System Concepts 6.15 Silberschatz, Galvin and Gagne 2002

 Examples of Exponential Averaging

  =0
 n+1 = n
 Recent history does not count.
  =1
 n+1 = tn
 Only the actual last CPU burst counts.
 If we expand the formula, we get:
n+1 =  tn+(1 - )  tn -1 + …
+(1 -  )j  tn -1 + …
+(1 -  )n=1 tn 0
 Since both  and (1 - ) are less than or equal to 1, each
successive term has less weight than its predecessor.

Operating System Concepts 6.16 Silberschatz, Galvin and Gagne 2002

 Priority Scheduling

 A priority number (integer) is associated with each

process
 The CPU is allocated to the process with the highest
priority (smallest integer  highest priority).
 Preemptive
 nonpreemptive
 SJF is a priority scheduling where priority is the predicted
next CPU burst time.
 Problem  Starvation – low priority processes may never
execute.
 Solution  Aging – as time progresses increase the
priority of the process.

Operating System Concepts 6.17 Silberschatz, Galvin and Gagne 2002

 Round Robin (RR)

 Each process gets a small unit of CPU time (time

quantum), usually 10-100 milliseconds. After this time
has elapsed, the process is preempted and added to the
end of the ready queue.
 If there are n processes in the ready queue and the time
quantum is q, then each process gets 1/n of the CPU
time in chunks of at most q time units at once. No
process waits more than (n-1)q time units.
 Performance
 q large  FIFO
 q small  q must be large with respect to context switch,
otherwise overhead is too high.

Operating System Concepts 6.18 Silberschatz, Galvin and Gagne 2002

 Example of RR with Time Quantum = 20

Process Burst Time

P1 53
P2 17
P3 68
P4 24
 The Gantt chart is:

P1 P2 P3 P4 P1 P3 P4 P1 P3 P3

0 20 37 57 77 97 117 121 134 154 162

 Typically, higher average turnaround than SJF, but better response.

Operating System Concepts 6.19 Silberschatz, Galvin and Gagne 2002

 Time Quantum and Context Switch Time

Operating System Concepts 6.20 Silberschatz, Galvin and Gagne 2002

 Turnaround Time Varies With The Time Quantum

Operating System Concepts 6.21 Silberschatz, Galvin and Gagne 2002

 Multilevel Queue

 Ready queue is partitioned into separate queues:

foreground (interactive)
background (batch)
 Each queue has its own scheduling algorithm,
foreground – RR
background – FCFS
 Scheduling must be done between the queues.
 Fixed priority scheduling; (i.e., serve all from foreground
then from background). Possibility of starvation.
 Time slice – each queue gets a certain amount of CPU time
which it can schedule amongst its processes; i.e., 80% to
foreground in RR
 20% to background in FCFS

Operating System Concepts 6.22 Silberschatz, Galvin and Gagne 2002

 Multilevel Queue Scheduling

Operating System Concepts 6.23 Silberschatz, Galvin and Gagne 2002

 Multilevel Feedback Queue

 A process can move between the various queues; aging

can be implemented this way.
 Multilevel-feedback-queue scheduler defined by the
following parameters:
 number of queues
 scheduling algorithms for each queue
 method used to determine when to upgrade a process
 method used to determine when to demote a process
 method used to determine which queue a process will enter
when that process needs service

Operating System Concepts 6.24 Silberschatz, Galvin and Gagne 2002

 Example of Multilevel Feedback Queue

 Three queues:
 Q0 – time quantum 8 milliseconds
 Q1 – time quantum 16 milliseconds
 Q2 – FCFS
 Scheduling
 A new job enters queue Q0 which is served FCFS. When it
gains CPU, job receives 8 milliseconds. If it does not finish
in 8 milliseconds, job is moved to queue Q1.
 At Q1 job is again served FCFS and receives 16 additional
milliseconds. If it still does not complete, it is preempted
and moved to queue Q2.

Operating System Concepts 6.25 Silberschatz, Galvin and Gagne 2002

 Multilevel Feedback Queues

Operating System Concepts 6.26 Silberschatz, Galvin and Gagne 2002

 Multiple-Processor Scheduling

 CPU scheduling more complex when multiple CPUs are

available.
 Homogeneous processors within a multiprocessor.
 Load sharing
 Asymmetric multiprocessing – only one processor
accesses the system data structures, alleviating the need
for data sharing.

Operating System Concepts 6.27 Silberschatz, Galvin and Gagne 2002

 Real-Time Scheduling

 Hard real-time systems – required to complete a critical

task within a guaranteed amount of time.
 Soft real-time computing – requires that critical processes
receive priority over less fortunate ones.

Operating System Concepts 6.28 Silberschatz, Galvin and Gagne 2002

 Dispatch Latency

Operating System Concepts 6.29 Silberschatz, Galvin and Gagne 2002

 Algorithm Evaluation

 Deterministic modeling – takes a particular

predetermined workload and defines the performance of
each algorithm for that workload.
 Queueing models
 Implementation

Operating System Concepts 6.30 Silberschatz, Galvin and Gagne 2002

 Evaluation of CPU Schedulers by Simulation

Operating System Concepts 6.31 Silberschatz, Galvin and Gagne 2002

 Solaris 2 Scheduling

Operating System Concepts 6.32 Silberschatz, Galvin and Gagne 2002

 Windows 2000 Priorities

Operating System Concepts 6.33 Silberschatz, Galvin and Gagne 2002