Forced Landing
Forced Landing
BRIEFING OUTLINE
AVGAS 100 LL NB – you should NEVER run out of fuel in the first place
Ex 8.3/4 ii
GLIDING NOTES
Gliding for time - longest time airborne if distance not main issue
- longer time airborne allows more time to complete
checks or correct fault
- WHEN – e.g. over water
- determined by min. power speed S/L flight
1. SPEED - BEST GLIDE SPEED Total Drag
D
Lift r Minimum
a Drag speed
g
Drag
Speed
DISTANCE
Ex 8.2 i
1. SPEED – FORCES IN THE GLIDE Both aircraft in
balanced flight
Straight
Lift
and level
Lift
Glide
Drag Thrust
Drag
Weight
Ex 8.2 i
Speed
SPEED - BEST ENDURANCE SPEED
P Power required
o
Lift w
e
r
Minimum power required speed
Drag
TIME
Ex 8.2 i
GLIDING – Effect of weight on the glide Lift
Resultant
D
Both aircraft gliding at r Minimum
a Drag speed
best L/D ratio speed
g
Speed
LIGHT Light
HEAVY Heavy
SAME DISTANCE !
Ex 8.2 i
GLIDING NOTES – EFFECT OF WEIGHT
You would expect that a heavy aircraft does not glide as far as a light one
Remember that heavy aircraft vs. light aircraft in S/L flight must fly faster
To produce sufficient lift to balance weight
Same situation here – both aircraft balancing weight with lift, but at
Different speeds
The end result is the same glide angle (just like S/L flight) except at
Different speeds
No flaps
With flaps
No gear
With gear
Pitch coarse
Pitch Fine
Less distance
NB – any increase in drag e.g. lowering flap or landing gear or setting a fine
propeller blade angle will increase drag and thus require a steeper angle of
descent to maintain best glide speed.
Aircraft glides at best L/D ratio – any change in one will have effect on range
Flaps – each stage of flap will increase DRAG – be careful not to lower
TOO SOON
Refer
POH for
Best glide speed
Ex 8.1 i-iii
GLIDING NOTES – EFFECT OF SPEED
Any change is this speed will alter the ratio and ultimately cause more
DRAG for less lift
END RESULT – once again glide angle is adjusted to fly this less than
optimum speed
Too slow – GLIDE ANGLE DECREASED, but decreased L/D ratio actually
results in less distance over the ground
AKA: attempting to STRETCH the glide
If this is endurance speed = MORE TIME
WIND
Ex 8.3/4 ii
GLIDING NOTES – EFFECT OF WIND
CONSIDERATIONS – HEADWIND
You will not reach same field you are used to in zero wind as less ground
distance
Slower ground speed on touchdown
CONSIDERATIONS – TAILWIND
Stall speed
Increases
Airspeed
decreases
Safety margin
Reduced
More height
loss in the
turn
GLIDING NOTES – EFFECT OF TURNS
generally increased AoA causes more drag which slows you down
MORE DRAG – SLOWER SPEED = lower the nose to maintain best glide speed
Margin between stall speed and airspeed reduces = potentially dangerous
Greater LOSS of height in descending turns – also main reason for NOT
sing high angles of bank or turning back to the field
2. FIELD – SELECTION
6 x S = size
shape
surface
slope
surrounds
Preferably: - FLAT
- LARGE ENOUGH TO LAND AND STOP
- INTO WIND
- OUT OF THE SUN
- UPSLOPE
- CLEAR OF OBSTACLES – Approach
- NEXT TO OTHER SUITABLE FIELDS
2. FIELD – PLAN THE APPROACH
1000 ft keypoint
GLIDING NOTES – PLAN THE APPROACH
his will give you a familiar routine and time to check for faults / radio call
hoose your aiming point 1/2 to 1/3 into the field and fly to keep in sight
y using left turns
ook for key points i.e. where to turn down wind and base
ly the pattern whilst you try to find the fault and restart the engine
EMEMBER - ANC
- Aviate – fly the aircraft first
- Navigate - select the field and fly the pattern
- Communicate - Mayday call if time and
situation permits
3. FAULT AND RESTART
You are on base leg / final approach and can see that you will be too high
In relation to your aiming point
As your aiming point moves under the nose extend more flap to increase
glide angle and keep it in the same place on the windscreen
The glide angle will increase, but use of flap will not increase speed too much
Evacuate
Instruct your
passengers
to evacuate
keeping clear
of the propeller
GLIDING NOTES – LANDING, TOUCHDOWN AND EVACUATION
With the aiming point in the proper place and landing flap extended
Complete final checks
- Reduce risk of fire by shutting down all systems – electrical and fuel