Scribd
Upload
13 views9 pages

Static Stress Analysis Using Inventor

Uploaded by

Nurul Nabilah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
13 views9 pages

Static Stress Analysis Using Inventor

Uploaded by

Nurul Nabilah
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 9

STATIC STRESS ANALYSIS

USING INVENTOR
STATIC STRESS ANALYSIS
FEA / STATIC STRESS ANALYSIS

Static stress analysis is arguably the most common type of structural analysis using FE
method. Stress, strain and deformation of a component or assembly can be investigated under
a range of load conditions to ensure that expensive failures are avoided at the design stage.

It can also be used as a tool to make decisions for your design.


START

DATA COLLECTION (DIMENSION)

3D DRAWING

ASSIGN MATERIAL

CONSTRAINS SETTING

LOAD SETTING

MESHING

RUN SIMULATION

RESUL NO
T OK?

YE
S
END
ANALYSIS
a) Von Misses Stress

Name Steel, Mild, Welded

Mass Density 7.85 g/cm^3

General Yield Strength 207 MPa


Ultimate Tensile
345 MPa
Strength
Young's Modulus 220 GPa

Stress Poisson's Ratio 0.275 ul

Shear Modulus 86.2745 GPa

Refer to the figures, it shows that the maximum value


of von misses stress for the design is 56.42 MPa which
is below yield strength of the material, it is means the
designs are safe.
ANALYSIS
b) Displacement

It is good for the design to have


small displacement. Its depend to
your design consideration.
ANALYSIS
c) Safety Factor

Result for safety factor shows that the designs


have maximum safety factor = 15. Minimum
safety factor = 3.67.

For safety factor, it is good to have the minimum


value = 2.
Design 1 Design 2 Design 3
Summary

Lowest

Lowest/
depend to design
consideration

Highest

Base on the criteria, all of three design are safe because the von misses stress value
is below yield strength, the displacement is acceptable, and safety factor above
2.00.

But, Design 2 is the best design for the frame modification. It has lowest maximum
von misses stress value that is 22.95 MPa and highest minimum safety factor value
which is 9.02. For displacement value, Design 2 in the middle compare to others.
10-Q

You might also like