0% found this document useful (0 votes)
20 views10 pages

Tannu

Uploaded by

lilharerakesh12
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
20 views10 pages

Tannu

Uploaded by

lilharerakesh12
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 10

SURYODAYA COLLEGE OF ENGINEERING & TECHNOLOGY, NAGPUR

DEPARTMENT OF ELECTRICAL ENGINEERING


Project Seminar
On
“Power Generation Using By Peltier Plate ”

PRESENTED
BY
1. Naman Kamble 3. Akshay Nimbalkar
2. Amar Parate
4. Pranay Ghode 5. Vaibhaiv Lonare

SEMESTER
7th
SESSION 2020-21

Prof. Rahul Dekate Prof. P. P. Titarmare


Guide Head of Department
Department of Department of Electrical
Electrical Engg.
Engg.
1
CONTENTS

Sr. No. Topics

1 Introduction

2 Aim of Project

3 Literature Survey

4 Hardware

5 Block Diagram

6 Advantages

7 References

Power Generation Using By Peltier Plate 2


1. Introduction

The Purpose of making this project is to generate electrical energy from bad materials like garbage and bad stuff

etc. and store that electrical energy in the battery through the circuit and use that electrical energy to operate the whole project.
And the LED bulb is shown to be turned on and the use of filters to control pollution from energy production. To burn the waste
material and to use that heat power generation we are using Peltier plates so by heating it the plates generate the voltage and
that voltage is used to charge the battery
The main aim behind this project is to reduce the pollution, and recycle the wastage and reuse them and finally to
produce the electricity from waste. Energy harvesting is the main focus of the researchers all over the world. It is because of
deployment of million sensor nodes and bottleneck of battery. This method avails various methods like piezoelectric,
electromagnetic, solar and thermoelectric. So in this our Project we show successfully How to generate electricity by Waste
Materials And Store electricity in Battery successfully .

Power Generation Using By Peltier Plate 3


2. Aim Of Project

• The main aim of this project is to recycle the wastage and reuse them and finally to produce the electricity from waste. Energy

harvesting is the main focus of the researchers all over the world

Power Generation Using By Peltier Plate 4


3. Literature Survey

In[1] “Preliminary Experiment for Electricity Generation using Peltier Modules“ by Sarinee Ouitrakul
78-1-4799-2993- 1 / 14 / $ 31.00 © 2018 IEEE
This paper presents a preliminary study of electricity generation using Peltier modules.
Ceramic thermoelectric cooling module (Peltier module),

In[2] “Low Cost Fabrication of Polymer Substrate Based Piezoelectric MicroGenerator With PPE,
IDE and ME , Accepted Manuscript , IET Electronics Letter “ by Suresh S.Balpande, ISSN 1350-
911XPrint 0013-5194 DOI : ISSN 10.1049 / el.2020.4099 .
This Letter presents the fabrication, characterisation and comparative evaluation of low-
frequency microgenerator using interdigitated electrodes (IDEs), parallel plate metal electrodes
(PPEs) and copper (Cu) mesh electrodes (MEs).

5
Power Generation Using By Peltier Plate
4. Block Diagram

Chimney Filter
Air fan

Peltier Plate Battery


Metal Plate

Inverter Load
Burning
tray
Ash
Collector

Power Generation Using By Peltier Plate 6


5. Hardware

• Arduino

• Peltier Plate

• L293D Driver

• CD Rom tray with DC motor

• Vacuum Pump

• Inverter

• Led Bulb

• 12V Battery

• Accessories : Chimney , Pipe , wire etc

7
Power Generation Using By Peltier Plate
6. Advantage

• The system will be fully automatic with enhanced sensors.


• The Supply of Water will be automatically cut of when the water is not pure.
• The Alarm System to alert the concern peoples

8
Power Generation Using By Peltier Plate
7.
References
• Suresh S.Balpande , Rajesh S.Pande , Rajendra M.Patrikar, “Design and Low Cost Fabrication of Green Vibration Energy
Harvestor , Elsevier , Sensors and Actuators ” May, 2019 International Journal of Emerging Trends in Electrical and Electronics
(IJETEE-ISSN: 2320-9569).
• Surash Balpande,“Low Cost Fabrication of Polymer Substrate Based Piezoelectric MicroGenerator With PPE, IDE
and ME , Accepted Manuscript , IET Electronics Letter ” ISSN 1350-911XPrint 0013-5194 DOI : ISSN 10.1049 /
el.2020.4099 .
• Sarinee Ouitrakul, “Preliminary Experiment for Electricity Generation using Peltier Modules.”, 78-1-4799-2993- 1 / 14 /
$ 31.00 © 2018 IEEE

9
Power Generation Using By Peltier Plate
10
Power Generation Using By Peltier Plate

You might also like