Scribd
Upload
50 views17 pages

CCNA 200-301 Chapter 7 - Configuring and Verifying Switch Interfaces

The document discusses configuring and verifying switch interfaces including setting speed, duplex, descriptions on interfaces, expanding subcommands, administratively disabling interfaces, removing interface configurations, autonegotiation results, and interface status codes and counters.

Uploaded by

kmjanjua19
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
50 views17 pages

CCNA 200-301 Chapter 7 - Configuring and Verifying Switch Interfaces

The document discusses configuring and verifying switch interfaces including setting speed, duplex, descriptions on interfaces, expanding subcommands, administratively disabling interfaces, removing interface configurations, autonegotiation results, and interface status codes and counters.

Uploaded by

kmjanjua19
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 17

CCNA 200-301, Volume I

Chapter 7 Configuring and


Verifying Switch Interfaces
Objectives
• Configuring Switch Interfaces
• Analyzing Switch Interface Status and Statistics
Configuring speed, duplex, and
description on Switch Emma

Emma#configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Emma(config)#interface FastEthernet 0/1
Emma(config-if)#duplex full
Emma(config-if)#speed 100
Emma(config-if)#description Server1 connects here
Emma(config-if)#exit
Emma(config)#interface range FastEthernet 0/11 - 20
Emma(config-if-range)#description end-users connect_here
Emma(config-if-range)#^Z
Emma#
How IOS Expands the Subcommands Typed
After interface range
Emma# show running-config
! Lines omitted for brevity
!
interface FastEthernet0/11
description end-users connect here
!
interface FastEthernet0/12
description end-users connect here
!
! Lines omitted for brevity
Administratively Disabling an Interface
with shutdown
The Different Status Information about
Shutdown in Two Different Show Commands

SW1# show interfaces f0/1 status

Port Name Status Vlan Duplex Speed Type


Fa0/1 disabled 1 auto 10/100BaseTX
Removing Configuration with the no
Command – Initial Configuration
Removing Configuration with the no
Command – After no Command
IEEE Autonegotiation Results with Both
Nodes Working Correctly
IEEE Autonegotiation Results with
Autonegotiation Disabled on One Side
IEEE Autonegotiation with a LAN Hub
LAN Switch Interface Status Codes
Displaying Speed and Duplex Settings on Switch Interfaces
Displaying Speed and Duplex Settings on Switch Interfaces
(Continued)
Conditions to Create a Duplex Mismatch
Between SW1 and SW2
Confirming Duplex Mismatch
Interface Counters for Layer 1 Problems

You might also like