Optisystem Presentation
Optisystem Presentation
Design and Performance Analysis of the WDM Schemes for Radio over
Fiber System With Different Fibre Propagation Losses Using
Optisystem Software
• The universal Internet traffic is increasing at a massive pace and is estimated to keep increasing
over the next few years.
• To support this growth, a future-proof network needs to be designed. This network needs to offer
large bandwidth and high data rate in a cost-effective way. If this network can combine wireless
and wired facilities together, then, along with high data rate, increased mobility can be achieved.
• RoF is a technique that combines both wired (optical) and wireless (microwave) networks. An RoF
network involves the transmission of RFs over an optical fibre link to support numerous wireless
applications.
• Fibre optic communication can be considered optical communication that combines the
methodologies of two communications, and it may be utilized in systems of wired and wireless
communication.
• The solution for many problems is radio over fiber (RoF) because it can control many base stations
(BS) that are connected to a central station (CS) with an optical fiber.
• The received RoF signal head for in a low quality; thus, many factors will result in some problems
such as a high bit error rate (BER) and low Q-factor values, and the receiver might not be operating in
a high data rate network.
• Wavelength division multiplexing (WDM) network can offer a solution to these problems where the
transmission of different signals can be done with a single-mode fiber. BER should be reduced to
assured values, and the Q-factor must be increased.
• The investigation of WDM-RoF with different lengths of fiber at various channel spacing will be
simulated using Optisystem software, and the RoF’s receiver performance is measured and analyzed
depending on the acquired BER, the value of the Q-factor.
• The degradation factors effect such as attenuation and dispersion are significantly limited with the
addition of an EDFA (Erbium-doped fiber amplifier) amplifier to a Single Mode Fibre (SMF).
Radio Over fiber (RoF)
Results & Discussion
References
• OptiSystem Download Link
https://optiwave.com/
• Video
(1880) Getting started with OptiSystem for beginners || tutorial series from basic to advanc
ed - YouTube
• User Manual
1. https://dru5cjyjifvrg.cloudfront.net/wp-content/uploads/2015/03/OptiSystem_Tutorials_Volu
me_1.pdf
2. https://cdn.optiwave.com/wp-content/uploads/2015/03/15150436/
OptiSystem_Tutorials_Volume_2.pdf
• Research paper
https://www.mdpi.com/2079-6439/7/3/19
Thank You