Scribd
Upload
51 views11 pages

7 DWDM System Protection Principle (Without OPCS)

The document discusses DWDM system protection principles. It describes a DWDM system hierarchy with four layers: optical multiplexing section (OMS), optical transport section (OTS), optical channel (OCH), and optical access (OAC). It then discusses how an optical protection (OP) card implements 1+1 protection at the OMS and OCH layers by executing protection handover or recovery commands based on received optical power or commands from a network management system. The working and protection paths are switched via a handover switch on the OP card.

Uploaded by

eyasu abebe ado
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
51 views11 pages

7 DWDM System Protection Principle (Without OPCS)

The document discusses DWDM system protection principles. It describes a DWDM system hierarchy with four layers: optical multiplexing section (OMS), optical transport section (OTS), optical channel (OCH), and optical access (OAC). It then discusses how an optical protection (OP) card implements 1+1 protection at the OMS and OCH layers by executing protection handover or recovery commands based on received optical power or commands from a network management system. The working and protection paths are switched via a handover switch on the OP card.

Uploaded by

eyasu abebe ado
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 11

DWDM System Protection Principle

Unitrans D&T Group


Contents

 DWDM System Hierarchy


 OP card
DWDM System Hierarchy

 Optical Multiplexing Section (OMS) layer


 Optical Transport (OTS) layer
 Optical Channel (OCH) layer
 Optical Access (OAC) layer.
DWDM System Hierarchy

OTM OTM
G.692 OLA
TX1 1 RX1
Optical 1 Optical
transponder
transponder
2 RX2
TX2 Optical 2 Optical
transponder transponder
RX3
TX3 Optical 3 OD 3 Optical
transponder OM OBA OLA OPA transponder

... ... RXn


TXn n n Optical
Optical
transponder transponder

OTS OTS

OMS
OAC OCH OAC
OP

 The OP implements the functions of line 1+1 protection of


OMS and 1+1 protection at the optical channel layer.
 According to the detected receive optical power or the forced
handover or recovery command from the NMS, the OP
executes the protection handover command or recovery
command.
 The handover and recovery are implemented via the handover
switch on the board.
Working Principle
OP Panel

TIN

TOUT1

TOUT2

ROUT

RIN1

RIN2
OMS 1+1 Protection
OCH 1+1 Protection (1)

OTU OTU
OP
Working path

Protection path OP

OTU OTU
OCH 1+1 Protection (2)

OP OP
主通道
Working path
OTU OTU

Protection
保护通道path
Features of 1+1 Protection

 Protection line is special and cannot be shared with other


working lines.
 Signaling support is not required. It can be implemented easily.
 It can be used in any network structure (point-to-point, ring or
grid network).
 It is a restorable protection without signaling support.
 Its bandwidth utilization ratio is low and cost is high.

You might also like