Effects of DG On Power System
Effects of DG On Power System
PRESENTED BY
BINOD GHIMIRE ( 2)
DEEPAK LAMICHHENA (3)
PRAMOD KHANAL (11)
UTSAV ADHIKARI (20)
INTRODUCTION
Centralized Transmission
220 &400
production KV
Distributi
on 20KV
Consumers
BIDIRECTIONAL SYSTEM WITH DG
Import /
Export
Centralized Ttansmission
220&400 KV
production
Micro-
units Consumer
s
EFFECTS OF DG ON ELECTRIC
POWER SYSTEMS
1) OPERATION AND CONTROL :
DG O/P is varied according to local load variation.
DG power O/P can also be varied independently if it
follows price signal.
Or follows the availability of natural resources like solar,
wind etc. which might or might not correspond to the
local load variations.
DG might adversely affect the voltage control
functionality of the network by increasing variations
between maximum and minimum voltage level.
Challenge to traditional voltage, frequency & power
control.
1. OPERATION AND CONTROL (contd…)
Due to large penetration of DG, there is a risk
of control and stability issues like if a CB opens
result in an islanding of DG unit.
If the loss-of-mains is not detected by the DG
unit, the DG unit will continue to operate.
If the DG unit is able to match active and
reactive power of the load in the islanded
system precisely, then it could continue to
operate without any problem.
1. OPERATION AND CONTROL (contd…)
1.0
Without DG
0.9
• Depends on
1. Characteristics (Rated power, mode of operation,
technology used)
2. Location of DG and N/W configuration
Overcurrent Protection may vary
Impact on Protection scheme of distribution grid
Protection system of DG unit should be able to
detect the fault and rapidly disconnect from the
network.
DG should not interfere with normal operation
PROTECTION SYSTEM REQUIREMENTS (Contd…) :
To be disconnect if fault occurs
LV system protection is based on fuse traditionally
Insufficient to operate DG protection
Modern Technology : Distribution n/w are
automated and equipped with SCADA system for
proper design and co-ordination
Case study is performed using Neplan Software for
the IEEE 14 systems
A DG source (3 MW wind turbine) is added and load
flow is calculated for DG source On-grid and Off-grid
Power Losses are lower if DG is On-grid
Case Study using Neplan Software
Results of the simulation
Wind Turbine Active Power losses Reactive Power losses
ΔP (MW) ΔQ (MVAr)