2 Metamorphic Classification
2 Metamorphic Classification
2 Metamorphic Classification
Figure 22.1. Examples of foliated metamorphic rocks. a. Slate. b. Phyllite. Note the difference in reflectance on the foliation surfaces
between a and b: phyllite is characterized by a satiny sheen. Winter (2001) An Introduction to Igneous and Metamorphic Petrology. Prentice
Hall.
Schist: a metamorphic
rock exhibiting a
schistosity. By this
definition schist is a broad
term, and slates and
phyllites are also types of
schists. In common usage,
schists are restricted to
those metamorphic rocks
in which the foliated
minerals are coarse
enough to see easily in
hand specimen.
Figure 22.1c. Garnet muscovite schist. Muscovite crystals are visible and silvery, garnets occur as large dark porphyroblasts. Winter (2001)
An Introduction to Igneous and Metamorphic Petrology. Prentice Hall.
Gneiss: a metamorphic rock
displaying gneissose
structure. Gneisses are
typically layered (also called
banded), generally with
alternating felsic and darker
mineral layers. Gneisses may
also be lineated, but must
also show segregations of
felsic-mineral-rich and dark-
mineral-rich concentrations.
Figure 22.1d. Quartzo-feldspathic gneiss with obvious layering. Winter (2001) An Introduction to Igneous and Metamorphic Petrology.
Prentice Hall.
Non-Foliated Metamorphic Rocks
Simpler than for foliated rocks
Again, this discussion and classification applies only
to rocks that are not produced by high-strain
metamorphism
Granofels: a comprehensive term for any isotropic
rock (a rock with no preferred orientation)
Hornfels is a type of granofels that is typically very
fine-grained and compact, and occurs in contact
aureoles. Hornfelses are tough, and tend to splinter
when broken.
Specific Metamorphic Rock Types
Marble: a metamorphic rock composed
predominantly of calcite or dolomite. The protolith
is typically limestone or dolostone.
Quartzite: a metamorphic rock composed
predominantly of quartz. The protolith is typically
sandstone. Some confusion may result from the
use of this term in sedimentary petrology for a
pure quartz sandstone.
Greenschist/Greenstone: a low-grade metamorphic
rock that typically contains chlorite, actinolite,
epidote, and albite. Note that the first three minerals are
green, which imparts the color to the rock. Such a rock
is called greenschist if foliated, and greenstone if
not. The protolith is either a mafic igneous rock or
graywacke.
Amphibolite: a metamorphic rock dominated by
hornblende + plagioclase. Amphibolites may be
foliated or non-foliated. The protolith is either a
mafic igneous rock or graywacke.
Serpentinite: an ultramafic rock metamorphosed at
low grade, so that it contains mostly serpentine.
Figure 22.2. Schematic cross section through a shear zone, showing the vertical distribution of fault-related rock types, ranging from non-
cohesive gouge and breccia near the surface through progressively more cohesive and foliated rocks. Note that the width of the shear zone
increases with depth as the shear is distributed over a larger area and becomes more ductile. Circles on the right represent microscopic views
or textures. From Passchier and Trouw (1996) Microtectonics. Springer-Verlag. Berlin.
High Strain Rocks
Figure 22.3. Terminology for high-strain shear-zone related rocks proposed by Wise et al. (1984) Fault-related rocks: Suggestions for
terminology. Geology, 12, 391-394.