Scribd
Upload
100 views12 pages

Position Checking Gauges

The document discusses position checking gauges for sheet metal parts with geometric dimensioning and tolerancing (GD&T). It asks several questions about designing gauges when GD&T or coordinate dimensions are provided, including how many gauges are required, what features need to be inspected before using a gauge, and whether grinding is needed to achieve tolerances. The document also provides information on a locating pin component, including its material properties and hardness.

Uploaded by

Moham'medAlthafAs'lam
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
100 views12 pages

Position Checking Gauges

The document discusses position checking gauges for sheet metal parts with geometric dimensioning and tolerancing (GD&T). It asks several questions about designing gauges when GD&T or coordinate dimensions are provided, including how many gauges are required, what features need to be inspected before using a gauge, and whether grinding is needed to achieve tolerances. The document also provides information on a locating pin component, including its material properties and hardness.

Uploaded by

Moham'medAlthafAs'lam
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 12

POSITION CHECKING

GAUGES
FOR A SHEET METAL
PART WITH GD&T
NOTE THAT THE
SLOT IS
PROVIDED IN
THE BASE PLATE
FOR UNLOADING
THE
COMPONENT
PERPENDICULARITY
GRINDING MUST BE
CARRIED OUT TO
ACHIEVE THIS
TOLERANCE, WHICH
IS VERY COSTLY

WHY SLOT?

DIMENSIONING THE PART WITH CONV. DATUMS


MATERIAL OF
THE PIN
- 20 Mn Cr5

HARDNESS –
58 TO 60 HRc

DESIGN OF LOCATING PIN


IS IT REQUIRED TO
GRIND DATUM
FEATURES IN THIS
CASE

IN THE FEATURE
CONTROL FRAME,
‘D’ IS TAKEN AS
DATUM
HOW DO YOU DESIGN A GAUGE WHEN NO
GD&T IS GIVEN IN THE DRAWING, i.e. WHEN
COORDINATE DIMENSION IS GIVEN

WHAT IS THE POLICY BEING FOLLOWED?


HOW MANY GAUGES ARE REQUIRED?
BEFORE USING THE POSITION CHECKING GAUGE,
WHAT DO YOU INSPECT?
DESIGN A GAUGE
TO CHECK THE
FOLLOWING
COMPONENT.

You might also like