Lecture slides on:

Basic Computer Hardware

Maintenance
Oda Bultum University office of
Information Technology Directorate
 Introduction to computer hardwares
 Basic operations
 Inside the box
 Motherboard
 Processor
 RAM & ROM
 Ports & Cabling
 Connectors & Expansion Card
 Storage & Hard Drives
 Power Supply
 Case
 Keyboard/mouse
 Power switch
 Network card
 Reset switch
 Modem
 Hard drive
 Sound card
 Floppy
 Video card
 CD/DVD
 RAM
 Zip drive
 Motherboard
 Serial ports
 Bus
 Parallel port
 Fan
 USB port
 Cables
 An electronic machine that can be
programmed to accept data
(input), and process it into useful
information (output). Data is put
in secondary storage (storage) for
safekeeping or later use.
 The processing of input into
output is directed by the
software, but performed by the
hardware.
 GI/GO
SOURCE: http://spruce.flint.umich.edu/~weli/courses/bus181/notes/chap4.html
 Power cord plugged in.
(If plugged into a power strip, turn it on. Includes
peripherals.)
 Cables to peripherals secure.
 Power on peripherals.
 Power on the system.
 Observe the system

for proper operation.

 Drives are housed in drive
bays which are accessed at
the front of the case.
 Internal drives, such as the
hard disk drive, are installed
in internal bays that are not
typically as accessible as the
external drives pictured here.
 System Unit cases come in a
huge array of types and styles,
depending upon hardware
needs.
Motherboard
ABIT KT7 RAID
The System Unit houses
the central processing unit,
memory modules,
expansion slots, and
electronic circuitry as well
as expansion cards that are
all attached to the
motherboard; along with
disk drives, a fan or fans to
keep it cool, and the power
supply.
All other devices (monitor,
keyboard, mouse, etc., are
linked either directly or
indirectly into the system
unit.
Sources: Tom’s Hardware site: http://www.tomshardware.com
 The motherboard is the main circuit  The BIOS is also responsible for allowing
board of a microcomputer. It contains you to control your computer's hardware
the central processing unit (CPU), the settings, for booting up the machine when
Basic Input/Output System (BIOS), you turn on the power or hit the reset
memory, mass storage interfaces, button, and various other system
functions.
serial and parallel ports, expansion
slots, and all the controllers for
standard peripheral devices like the
keyboard, disk drive and display
screen.
 BIOS stands for Basic Input/Output
System. It is the lowest-level software
in the computer; it acts as an interface
between the hardware (especially the
chipset and processor) and the
operating system. The BIOS provides
access to the system hardware and
enables the creation of the higher-level
operating systems that you use to run
your applications.
ABIT SE6
The CPU has 2 fundamental sections:
the Control Unit, and the Arithmetic Logic
Unit. These work together to perform
processing operations.
Fundamentally all processors do the
same thing. They take signals in the form
of 0s and 1s (thus binary signals),
manipulate them according to a set of
instructions, and produce output in the
form of 0s and 1s. The voltage on the line
at the time a signal is sent determines
whether the signal is a 0 or a 1. On a 3.3-
volt system, an application of 3.3 volts
means that it's a 1, while an application
of 0 volts means it's a 0.
Other components of the CPU include
the Registers and the System Clock. A
processor’s clock speed is measured in
Megahertz (MHz) and Gigahertz (GHz).
Clock speed is the speed at which a
processor executes instructions. A
Pentium IV typically has a clock speed of
1.4 GHz.

Further research: Buses,

System Bus, Expansion Bus
 RAM is Primary Storage, also called internal storage.
 Serves as computer’s workspace, storing all or part of
the program that is being executed, as well as data
being used by the program.
 RAM stores the operating system programs that
manage the operation of the computer.
 RAM is Volatile storage:
◦ Power goes, data goes!
 More memory = larger workspace
◦ Large programs = large number of instructions
◦ Measured in Bytes (KB, MB, GB, etc.)
 Data/instructions are copied into memory as needed.
◦ Not enough memory or corruption of
data/instructions in memory can cause crash.
 Aside from the processor, the two most important factors
affecting a computer system’s performance are RAM and hard
disk capacity.
 Hard disks are typically huge, with GBs of storage, so the
primary limiting factor is the amount of installed RAM.
 Without enough RAM, the operating system must swap out
storage space with your hard disk. The OS creates a Paging
File (swap file) to supplement RAM (workspace). This is
Virtual Memory.
 Virtual memory is inherently slow! RAM speed can typically
be 120,000 times FASTER than the hard disk—so the less you
must rely on virtual memory (swapping files between RAM
and hard disk), the faster your system will perform.
 RAM provides instructions and data to the CPU. These instructions/data are
coded in bytes. Each byte is placed in a precise location in memory, called an
address. To access data or instructions in memory, the computer references
the addresses containing the bytes.
 The amount of memory available is therefore measured in bytes:
 Virtual memory to maximize RAM

Approx. Pages
Name Abbreviation Approx. # of Bytes Exact # of Bytes
of Text
Bit bit One 1 or 0 One character
Byte B Eight character Eight bits Eight characters
Kilobyte KB (or K) One thousand 1,024 One-half page
Megabyte MB One million 1,048,576 500 pages

Gigabyte GB One billion 1,073,741,824 500,000 pages

500,000,000
Terabyte TB One trillion 1,099,511,627,776
pages
 Ram chips consist of millions of  RAM chips are typically packaged
switches that are sensitive to on small circuit boards called
changes in electric current. When memory modules, which are
you turn on your computer, inserted into special slots on the
operating system files are loaded motherboard.
from a storage device (the hard  DIMMs, or dual inline memory
disk, usually) into RAM, and they modules provide a 64-bit data
remain there as long as your path to the processor. Older
computer is running. RAM SIMMs only provide a 32-bit path.
contents changes as programs  The amount of RAM needed
are executed. depends on the types of
 Two basic types of RAM are applications you intend to run on
Dynamic RAM (DRAM), and Static the computer. Software
RAM (SRAM). Most computers programs indicate the minimum
today use DRAM (specifically, amount of RAM required to run.
Synchronous DRAM or SDRAM), How much RAM determines how
which is faster because it is many programs and how much
synchronized to the system clock. data your computer can handle at
one time.
Topic not covered: The Cache
 ROM is nonvolatile. ROM
chips contain permanently  Flash memory is
written data, called
firmware (your BIOS lives reprogrammable memory.
here). You can upgrade the logic
 ROM contains the programs capabilities by simply
that direct the computer to downloading new software.
load the operating system This saves the expense of
and related files when the replacing circuit boards and
computer is powered on. chips.
 ROM chips are usually
recorded when they’re
manufactured.
 Coding schemes, such as ASCII,
EBCDIC, and Unicode, provide the
means to interact with a
computer that recognizes only
bits (on/off states).
 When you press a letter on a
keyboard, the electronic signals
are converted into binary form
and stored into memory. The
computer then processes the data
as bytes of information and
converts them to the letters you
see on the monitor screen or on a
printed page. SOURCE: http://spruce.flint.umich.edu/~weli/courses/bus181/notes/chap4.html
 Ports are sockets that allow
you to plug in device
connectors to access the
common electrical bus on the
motherboard.
 Ports are usually found on the
back of the system unit, but
newer styles also have some
of them conveniently located
on the front.
 Ports allow specific types of
connectors (which partly
reflects changing technology
as well as various kinds of
technology).
  Serial ports transmit data one bit
at a time, like the picture on the
left illustrates.
 Parallel ports transmit more than
one byte at a time.
 These types of port designs are
based on whether or not fast data
transmission rates are required
by the device or not.
 Most computers come with basic
types of ports (serial, parallel,
keyboard, mouse, and USB); and
expansion cards allow you to
expand the available types
needed by specific devices.

Other types to look up and read about:

SCSI, USB, Fire Wire, and MIDI.
  Understanding the
differences among
connector types is useful
and important, as the
cable required to attach a
device to your computer is
specific to its connector,
not to mention the port
on the computer.

Fire wire connectors and port.

(Also called IEEE 1394)
 •Expansion Cards plug into the expansion
slots found on the motherboard.
Convenient way to add extra ports or
expand the computer’s capabilities.

Accelerated Graphics Port (AGP)

Peripheral Component Interconnect (PCI)
 Expansion slots are sockets to  For further research about
provide direct connections to connecting devices to your
the common electrical bus, computer, look up:
allowing you to insert a circuit ◦ Peripheral Component
board into the motherboard. Interconnect (PCI)
 Typical Expansion Cards: ◦ Accelerated Graphics Port (AGP)
◦ Video Cards ◦ Industry Standard Architecture
◦ Sound Cards (ISA)
◦ Modem Cards ◦ Universal Serial Bus (USB)
◦ Network Interface Cards (NIC)
◦ Small Computer System
 Laptops and portable Interface (SCSI)
computers typically have PC ◦ Integrated Drive Electronics
Cards – thin credit-card sized (IDE)
devices used to add memory,
disk drives, etc.
 Disk drives
◦ Internal & External
◦ Hard drives Master Blue color & slave
yellow color to use external HD
◦ Removable disk drives
 Floppy disks (1.4 MB)
 ZIP disks (100/250 MB)
 CD-ROM (700MB), DVD-ROM (~5GB/side)
 read only (-ROM), write once (-R), re-writeable
(-RW)
 Combination drive
 CD-RW/DVD-ROM, CD-RW/DVD-R
 Many other forms
 Memory Stick, MultiMediaCard,
CompactFlash, and SmartMedia
  IEEE 1394, commonly called Fire Wire, is a
very fast external bus standard that
supports data transfer rates of up to
400Mbps (in 1394a) and 800Mbps (in
1394b).
 Products supporting the 1394 standard go
60 GB External Hard Drive under different names, depending on the
company. Apple, which originally
(Fire Wire) developed the technology, uses the
trademarked name FireWire. Other
Universal Buslink Corp. companies use other names, such as i.link
and Lynx, to describe their 1394 products.
 A single 1394 port can be used to connect
up 63 external devices. In addition to its
high speed, 1394 also supports
Iomega 60GB Portable isochronous data -- delivering data at a
guaranteed rate. This makes it ideal for
USB Hard Drive devices that need to transfer high levels of
data in real-time, such as video devices.
 Although extremely fast and flexible, 1394
is also expensive. Like USB, 1394 supports
both Plug-and-Play and hot plugging, and
also provides power to peripheral devices
Further research: Universal
Serial Bus (USB)
Power issues are largely ignored by most computer users, but a properly working power
supply is the foundation to correct operation of the system. When the power supply stops
working, the computer stops working, and when a power supply stops functioning properly—
even slightly—all sorts of computer problems can take place. From unexpected system
reboots to data corruption, from unrecognized bus-
powered USB devices to system overheating, a bad power supply is bad news. The power
supply is vital to the health of the computer. So, if your computer is acting “sick,” you should
test the power supply to see if it’s the cause. To keep the power supply working properly,
use surge suppression and battery backup (UPS) units. The power supply is really
misnamed: It is actually a power converter that changes high-voltage alternating current
( AC ) to low-voltage direct current (DC). There are lots of wire coils, capacitors, and other
components inside the power supply that do the work, and during the conversion process, a
great deal of heat is produced. Most power supplies include one or two fans to dissipate the
heat created by the operation
of the power supply; however, a few power supplies designed for silent operation use
passive heat sink technology instead of fans. On power supplies that include fans, fans also
help to cool the rest of the computer. Figure 4-1 shows a typical desktop computer’s power
supply
The power supply shown in Figure 4-2 is a so-
called “split rail” design with two separate 12V
outputs (+12V 1 and +12V 2). This type of
design is frequently used today to provide
separate 12V power sources for processors
(which reduce 12V power to the power level
needed) and other devices such as PCI Express
video cards, fans,
and drives). Add the values together to get the
total 12V output in amps (34A).
Power supplies that do not bear the UL or other
certification marks should not be used, as their
safety is unknown.
Most power supplies are designed to handle

two different voltage ranges:

110–120V/60Hz America standard
220–240V/50Hz Ethiopian standard
Cmos Battery : Adjust Date Time
Jumper - to forget date time unplug
Fun - power supply,mother board ,cpu
Blower -To clean dust NB unplug power cord
Pictures & info obtained from:
www.cnet.com
www.zdnet.com
www.techtv.com
www.pcguide.com
www.webopedia.com
http://spruce.flint.umich.edu/~weli/courses/
bus181/notes/chap4.html