Scribd
Upload
130 views14 pages

CC216 Digital Logic Design: LAB Work #4

Uploaded by

aya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
130 views14 pages

CC216 Digital Logic Design: LAB Work #4

Uploaded by

aya
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 14

CC216 Digital Logic Design

LAB Work #4
Lab outline:

• Introduction to ICs.
• How to use Datasheets.
• Construct a circuit to connect an
AND gate.
Introduction to ICs
• Two major fixed function logic families are
TTL (74 series) and CMOS (4000 series).

• How to read the number of an IC?

Family IC #
Introduction to ICs

• How to identify the pin numbers in an IC?


?

How to use Datasheets?

IC Description
number
7400 4 2-input NAND gate
7402 4 2-input NOR gate
7404 6 INVERTORS gate
7408 4 2-input AND gate
7432 4 2-input OR gate
7486 4 2-input XOR gate
Circuit Diagram

1) Connect the logic circuit as


shown in figure 1.
 
2) Using a specific Truth Table,
open and close the switches
to
show the effect of logic 0
and
logic 1 on the LED (Light
Emitting Diode).

Experiments for Digital Fundamentals, 10th ed Copyright © 2009 Pearson Education, Inc.,
By David M. Buchla Upper Saddle River, NJ 07458 • All rights reserved.
AND Gate Truth Table

Inputs Output
B A Y
0 0 0
0 1 0
1 0 0
1 1 1

Output Expression:

Y = AB

Experiments for Digital Fundamentals, 10th ed Copyright © 2009 Pearson Education, Inc.,
By David M. Buchla Upper Saddle River, NJ 07458 • All rights reserved.
Circuit Diagram

Experiments for Digital Fundamentals, 10th ed Copyright © 2009 Pearson Education, Inc.,
By David M. Buchla Upper Saddle River, NJ 07458 • All rights reserved.
AND gate circuit
step1:connect two inputs to the switch as previously
described
AND gate circuit
step2:Insert the AND gate (7408)
AND gate circuit
step3:connect pin 1 and 2 of the AND gate to the
two switch points
AND gate circuit
step4:connect pin 7 and 14 of the AND gate to the
GND and VCC of the board
AND gate circuit
step5:connect the output of the AND gate (pin 3) to
the LED
AND gate circuit
step6:try the circuit by switching ON/OFF the buttons
according to the AND gate TRUTH TABLE.

INPUTS OUTPUT

0 0 0 (LED OFF)

0 1 0 (LED OFF)

1 0 0 (LED OFF)

1 1 1 (LED ON)

You might also like