CAMBRIDGE CHECKPOINT SCIENCE
Physics
Unit 13: Magnetism
13.4 Making electromagnet
Learning objectives
1. To describe how to make an electromagnet
2. To describe the uses of electromagnet
Magnetic fields
A magnetic field is a volume of space
where magnetic force is exerted.
All magnets are surrounded by magnetic
fields.
Induced Magnetism
Magnetism can be induced in a
magnetic material if it is placed within a iron bar
magnetic field.
N
If the material is magnetically hard it will
retain its magnetism once removed from
S
the field.
Electromagnetism
In 1820 Hans Ørsted noticed
that a wire carrying an electric No current, Current,
current caused a compass compass compass
needle to deflect. points to north deflected
Electricity and Magnetism
In an electric circuit, batteries provide an electric field
to push charges through a wire, which provides a
path for them to flow.
Compasses around a circuit with flowing electric
current detect a magnetic field.
Magnets can push or pull on a wire with current
flowing through it.
Magnetic field patterns around a Electricity
straight wire and
Magnetism
Magnetic field patterns around a Electricity
straight wire and
Magnetism
• The magnetic field consists of concentric
circles centred on the wire.
• The magnetic field is strongest near the
wire.
• This is shown by the field lines being closest
together near to the wire.
• The strength of the field increases if the
electric current is increased.
Hard and Soft Magnetic Materials
Permanent magnets are made of magnetically HARD materials such as steel.
These materials retain their magnetisation once magnetised.
Magnetically SOFT materials, such as iron, lose their magnetisation easily.
They suitable for temporary magnets such as electromagnets.
Electromagnets
Electromagnet is a device in which magnetism is
produced by an electric current.
It consists of a current carrying coil
wrapped around an iron coil.
Making an electromagnet
A coil with some magnetic material called
a core is use to make an electromagnet.
The core becomes magnetised by the
magnetic of the coil.
The switch turns the electromagnet on
and off because the magnetic field is only
produce when a current is flowing in the
wire.
The iron core does not remain
magnetised when you turn the
electromagnet off
The uses of electromagnet Scrap Yard
Crane
The iron core of the electromagnet is a SOFT
magnetic material.
When current flows the iron becomes strongly
magnetised and so picks up the scrap iron and steel.
When the current is turned off the iron loses its
magnetisation and so releases the scrap.
The uses of electromagnet The electric
bell
push
switch spring
When the push switch is closed current flows around the
circuit turning on the electromagnet.
electromagnet
The soft iron armature is pulled towards the electromagnet
and the hammer hits the gong.
This causes the contact switch to open cutting off the
electric current.
contact
switch The spring now pulls the armature back again closing the
contact switch.
soft iron
armature hammer Current now flows again and the hammer hits the gong
again.
gong
The uses of electromagnet The relay
switch
switch A
iron
armature
A relay switch is a way of using a low voltage
circuit to switch remotely a high voltage
(and possibly dangerous) circuit.
electromagnet When switch A is closed, the small current
provided by the cell causes the
hinge
electromagnet to become magnetised.
The iron armature is then attracted to the
springy to high
contact voltage
electromagnet causing the springy contact
switch B circuit switch B to close in the high voltage circuit.
The uses of electromagnet Circuit
breaker
2
Current normally flows between terminals A and B through
the contact and the electromagnet.
When the current in a circuit increases, the strength of the
electromagnet will also increase. This will pull the soft iron
1 armature towards the electromagnet.
As a result, spring 1 pulls apart the contact and
A disconnecting the circuit immediately, and stopping current
flow.
B Domestic
circuit
The reset button can be pushed to bring the
contact back to its original position to reconnect breakers
the circuit
Classwork/ Homework
1. Cambridge Checkpoint Science Coursebook
Page 168- 169 Question 1- 3
1. An electromagnet uses electricity but a permanent magnet does not. An
electromagnet can be switched on and off, but a permanent cannot.
2. Switch the electric current on and off, or connect /disconnect the battery.
3. No, wood is not a magnetic material
