Scribd
Upload
179 views21 pages

Motor Speed Monitoring Control System & GSM Modem

This document describes a project to design an embedded device that can control up to 8 devices remotely via SMS messages sent from a mobile phone. A GSM modem connected to a microcontroller receives SMS messages and extracts the control signal, which is then sent to the devices. An LCD interface displays the messages. The system provides remote control capabilities without wired connections and saves time over traditional methods. It uses GSM for communication, which is widely available, low-cost, and reliable.

Uploaded by

Aditya Tomar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
179 views21 pages

Motor Speed Monitoring Control System & GSM Modem

This document describes a project to design an embedded device that can control up to 8 devices remotely via SMS messages sent from a mobile phone. A GSM modem connected to a microcontroller receives SMS messages and extracts the control signal, which is then sent to the devices. An LCD interface displays the messages. The system provides remote control capabilities without wired connections and saves time over traditional methods. It uses GSM for communication, which is widely available, low-cost, and reliable.

Uploaded by

Aditya Tomar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 21

By

Monu Mishra (10805734)


Adarsh Kumar Pandey (10804668)
Aditya Pratap Singh Tomar (10802820)
 Introduction
 Objective
 Need
 Component Used
 Specifications
 Block Diagram
 GSM Modem
 Advantages
 Conclusion
 In this project the design aspects of an
embedded device which can control up to 8
devices by sending a specific SMS message
from a mobile phone are presented.
 This controller is extremely handy at places
where we have to control the ON and OFF
switching of the devices but no wired
connection to that place is available.
 To implement this, a GSM modem is
connected to a programmed microcontroller
which would receive the SMS from a reference
cell phone.
 The control signal part of the received SMS is
extracted and is changed to microcontroller-
preferred format.
 A PC which is connected to the
microcontroller using a serial communication
through RS232 can be used for monitoring
and transmission of the control signals to the
modem.
 AT commands were used for controlling the
functionality of GSM modem is vastly used
because of its simplicity in both transmitter
and receiver design, can operate at 900 or
1800MHZ band, faster, more reliable and
globally network.
 The monitoring is also done by interfacing a
LCD to the microcontroller.
 Here the system is capable of controlling the
motor by receiving control message from an
authorized mobile number.
 Microcontroller is the heart of our system,
which controls the overall operation of our
system.
 System is always alert for receiving SMS from
valid number and that message can be
displayed on the LCD(Liquid Crystal Display).
 In the project work undertaken, GSM
technology based automatic control system is
designed to monitor and control speed of an
Induction motor/DC motor and also performs
necessary operation like start, stop, reverse
the rotation etc.
 This project is made to Innovate the old one
into a new one.
 That’s mean we are using the new technology
 Time saving is main objective.
 Advancement
 Time
 Speed
 Accuracy
 Reliable
 Flexible
 Efficient & Effective
 Power supply
 Regulated PS
 Microcontroller
 Motor
 GSM Modem
 Modem Connector
 Power Supply – 440/220 v, 50 Hz
 Regulated PS - 5v and 4.6v, 12v DC
 Microcontroller – 8255A
 Motor – AC/DC Motor
 GSM Modem – Nokia/ Samsung Mobile
 DTMF (Dual Tone Multi Frequency)
 A DTMF is used to decode the frequency and
to give the instructions to microcontroller.
 Regulated Power Supply
 It is rectified ac 220 v to regulated 5 v dc.
 A TRIAC, or TRIode for Alternating Current is
an electronic component approximately
equivalent to two silicon-controlled rectifiers
(SCRs/ thyristors) joined in inverse parallel
(paralleled but with the polarity reversed) and
with their gates connected together. The
formal name for a TRIAC is bidirectional
triode thyristor.
 GSM –Global System for Mobile
Communication.
 A GSM modem is a wireless modem that
works with a GSM wireless network.
 sends and receives data through radio waves.
 Like a GSM mobile phone, a GSM modem
requires a SIM card from a wireless carrier in
order to operate.
 GSM modems can be a quick and efficient
way to get started with SMS
 GSM modems are a cost effective solution for
receiving SMS messages.
 Security
 Time saving
 Cost saving
 Uses
 Availability
 Effectiveness
 Reliability
 GSM Technology has changed the living
standard of human being.
 In current era almost every one is using GSM
Mobile.
 Implementation of GSM Technology has
changed working style of the industry.
 And now it is used widely almost in the every
where.
Thanks

You might also like