Scribd
Upload
31 views25 pages

Tidal Power (CH 5.4, 5.9-5.10) : Phys 105 Dr. Harris 4/1/13

The document discusses various methods of harnessing tidal power, including tidal barrages, tidal turbines anchored to the ocean floor, and the history of tidal power generation back to tide mills in the 8th century. It also covers ocean thermal energy conversion (OTEC) and some examples of domestic tidal power projects. While tidal power is renewable, the document notes it is intermittent and expensive compared to other generation methods.

Uploaded by

Suresh Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
31 views25 pages

Tidal Power (CH 5.4, 5.9-5.10) : Phys 105 Dr. Harris 4/1/13

The document discusses various methods of harnessing tidal power, including tidal barrages, tidal turbines anchored to the ocean floor, and the history of tidal power generation back to tide mills in the 8th century. It also covers ocean thermal energy conversion (OTEC) and some examples of domestic tidal power projects. While tidal power is renewable, the document notes it is intermittent and expensive compared to other generation methods.

Uploaded by

Suresh Kumar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 25

Tidal Power (Ch 5.4, 5.9-5.

10)
Phys 105
Dr. Harris
4/1/13
What Causes Tides?

• http://www.pbs.org/wgbh/nova/earth/what-causes-the-tides.html
high tide

low tide
History of Tidal
• Tidal energy is one of the oldest forms of energy used by humans
• Dating back to 787 A.D., tide mills were constructed, consisting of a
storage pond and a sluice (gate that controls water flow).
– During the incoming tide (flood), the sluice would open to allow rising
waters to fill the storage pond
– During the outgoing tide (ebb), the stored water would be released
over a waterwheel

• In the early 1960’s, the first commercial scale tidal power plant was built
in St. Malo, France, consisting of twenty four 10MW turbines.
Tidal Barrages
• The ocean’s tides can be used to accumulate potential energy, which can
be converted to mechanical energy by turning a turbine in a manner quite
similar to hydropower.

• As the tides rise and fall daily, basins along the shoreline naturally fill and
empty. A complete tidal cycle takes 12.5 hours, so there are two high tides
and two low tides a day.

• Dam-like structures called barrages can be built across the mouths of


natural tidal basins with sluice gates. Water can be allowed to rise on one
side of the sluice until enough of a hydraulic head is built up to power a
turbine.

• The turbines are designed to work in either direction to maximize the


utilization of the changing tide.
Tidal Barrages
Rance River Tidal Power Station

• The first commercial tidal


power plant in the world is
the La Rance Tidal Barrage
in France built in 1967.

• The average tidal range is


28 ft, with a max of 44 ft.
The barrage extends 2500
ft across.

• Produces 5.4 GWh of


electricity per year, which
is only 18% of the available
energy in the basin.
Tidal Turbines

• Efforts are underway to anchor turbines to the ocean floor to harness tidal
energy. This concept is proven, and in practice in a handful of locations on
a small scale.

• This form of generation has many advantages over its other tidal energy
rivals. The turbines are submerged in the water and are therefore out of
sight. They don’t pose a problem for navigation and shipping and require
the use of much less material in construction.

• Tidal turbines are vastly better than wind turbines in terms of efficiency. A
tidal turbine produces 4 times the output power per square meter of
sweep area as a wind turbine, with a substantially smaller environmental
impact.
Siemens “SeaGen (S)” Tidal Turbine
Domestic Tidal Power

• There are no tidal power stations in the U.S., but plans are underway to
build a small tidal power farm in the East River of NYC.
– 300 underwater turbines
– On average, 10 MW of power (44GWh of electricity per year, enough
for 8000 households)

• Alaska, Maine, and southeast Canada are potential target areas for
barrages.
Ocean Thermal Energy Conversion (OTEC)

• The world’s oceans constitute a vast natural reservoir for receiving and
storing heat energy from the sun

• Nearly 75% of the surface area of Earth is water. Due to the high heat
capacity of water, the, water near the surface is maintained at significant
higher temperatures than water at greater depth

• It is possible to extract energy from the oceans through the use of heat
engines in order to exploit the temperature differences between warm
surface water and the cold, deep water
Oceanic Temperature Differences Between
Surface and 1000m Depth
Closed-Cycle OTEC System

• Closed-cycle systems have been considered for OTEC.


– In such a system, a low heat capacity working fluid passes through a
heat exchanger (evaporator) which
– The vapor passes through an expansion valve and forces the rotation
of a turbine
– Cold water from the depths cools the condenses the working fluid via
heat exchanger, and the process repeats.
Example

• Using the water temperatures from the last slide, calculate the theoretical
efficiency of an ideal heat engine?

𝑇𝑐𝑜𝑙𝑑 278
η= 1− 𝑥 100% = 1 − 𝑥 100% = 6.7%
𝑇ℎ𝑜𝑡 298

• Of course, this is the maximum possible efficiency for an ideal system.


The actual efficiency would be closer to 3%.
• To produce 40MW, the water intake pipes would need to be 10m in
diameter, about the size of a traffic tunnel.
• Average coal plant: 670 MW
Advancing OTEC?
• The OTEC concept was first introduced in 1881. In 1930, the first OTEC
test system was constructed.

• This test system was open-cycle. Unfortunately, the system consumed


more power than it produced.

• Very little was done after this until the 1970’s when rising fuel costs
prompted the US to reopen studies of OTEC
– The Department of Energy financed the design of a large floating OTEC
plant intended to provide power to the islands, with transmission lines
running along the ocean floor
– A small test plant (10 kW) was built in the late 70’s and operated
successfully for four months off the coast of Hawaii. Since then, there
has been no support of OTEC technology
Wave Energy
• The kinetic energy of moving
waves can be used to power a
turbine.
• In this simple example the wave
rises into a chamber. The rising
water forces the air out of the
chamber. The moving air spins a
turbine which can turn a
generator.
• When the wave drops, this
creates a vacuum in the
chamber, causing air to flow in
the opposite direction
Advantages

• Renewable and clean


• Tides are predictable
• There is a vast potential for energy generation
• With tidal turbines, the structures are out of sight
• Less required material for tidal turbines than wind
Disadvantages

• Like wind and solar, tidal power is intermittent


– In addition, the hydraulic head obtained from tides is also variable

• Tides do not align with peak energy demand times

• With regard to barrages, some of the environmental impacts of dams are


present with this technology as well, though to a much lower extent

• VERY, VERY, VERY EXPENSIVE


– Only produces 1/3 of the electricity that a hydropower plant of equal
size would produce
– Wave power sites produce low energy output

You might also like