Scribd
Upload
974 views8 pages

Introduction To Data Acquisition

This document provides an introduction to data acquisition systems. It discusses the five main components of a basic DAQ system: transducers and sensors, signals, signal conditioning, DAQ hardware, and driver/application software. It focuses on transducers that convert physical phenomena into electrical signals, the two types of signals (analog and digital), and how signal conditioning is used to optimize signals for accurate measurement by the DAQ device.

Uploaded by

Praveen Singh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
974 views8 pages

Introduction To Data Acquisition

This document provides an introduction to data acquisition systems. It discusses the five main components of a basic DAQ system: transducers and sensors, signals, signal conditioning, DAQ hardware, and driver/application software. It focuses on transducers that convert physical phenomena into electrical signals, the two types of signals (analog and digital), and how signal conditioning is used to optimize signals for accurate measurement by the DAQ device.

Uploaded by

Praveen Singh
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 8

Introduction to Data Acquisition

Data acquisition involves gathering signals from


measurement sources and digitizing the signal for
storage, analysis, and presentation on a PC.
There are five components to be considered when
building a basic DAQ system :
Transducers and sensors
Signals
Signal conditioning
DAQ hardware
Driver and application software
The Typical PC-Based DAQ System
Transducers and Signal Conditioning

Transducers sense physical phenomena and produce electrical


signals that the DAQ system measures.
For example,thermocouples, resistance temperature detectors
(RTDs), thermistors, and IC sensors convert temperature into an
analog signal that an analog-to-digital converter (ADC) can
measure.
Other examples include strain gauges, flow transducers, and
pressure transducers, which measure force, rate of flow, and
pressure, respectively. In each case, the electrical signals produced
are proportional to the physical parameters they monitor.
The electrical signals generated by the transducers must be
optimized for the input range of the DAQ device. Signal conditioning
accessories amplify low-level signals and then isolate and filter them
for more accurate measurements.
In addition, some transducers use voltage or current excitation to
generate a voltage output.
Phenomena and Existing Transducer
Signals

Signals can be categorized into two groups:


Analog--An analog signal can be at any value
with respect to time, e.g. voltage, temperature,
pressure, sound, and load. The three primary
characteristics of an analog signal include level,
shape, and frequency
Digital--a digital signal has two possible levels:
high and low. The useful information that can be
measured from a digital signal includes the state
and the rate.
Signal Conditioning
Sometimes transducers generate signals too
difficult or too dangerous to measure directly with
a DAQ device.
For instance, when dealing with high voltages,
noisy environments, extreme high and low
signals, or simultaneous signal measurement,
signal conditioning is essential for an effective
DAQ system.
Signal conditioning maximizes the accuracy of a
system, allows sensors to operate properly, and
guarantees safety.
Signal conditioning accessories can be
used in a variety of applications including:
Amplification
Attenuation
Isolation
Bridge completion
Simultaneous sampling
Sensor excitation
Multiplexing
Signal Conditioning Hardware
Options

You might also like