Scribd
Upload
29 views11 pages

Deconvolution: Presented By: Erwandi Yanto Pangaribuan 1606841244 Ronald H. Simanungkalit 1606841521

1. The document summarizes the basic concepts of seismic deconvolution, which is an inverse filtering technique used to compress the seismic wavelet and attenuate multiples. 2. Deconvolution aims to increase vertical resolution and approximately recover the earth's impulse response or reflectivity. 3. It can be applied before or after stack, and uses mathematical models of the source wavelet, noise, and Q-effect to modify the seismic trace.

Uploaded by

Ahmad Jahrudin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
29 views11 pages

Deconvolution: Presented By: Erwandi Yanto Pangaribuan 1606841244 Ronald H. Simanungkalit 1606841521

1. The document summarizes the basic concepts of seismic deconvolution, which is an inverse filtering technique used to compress the seismic wavelet and attenuate multiples. 2. Deconvolution aims to increase vertical resolution and approximately recover the earth's impulse response or reflectivity. 3. It can be applied before or after stack, and uses mathematical models of the source wavelet, noise, and Q-effect to modify the seismic trace.

Uploaded by

Ahmad Jahrudin
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 11

Master Degree

Reservoir Geophysics Department

Basic of Seismic Processing


Dr. Teguh Suroso

Deconvolution
Presented by :
Erwandi Yanto Pangaribuan 1606841244
Ronald H. Simanungkalit 1606841521

DECONVOLUTIO
N

Definition

Deconvolution Objective

Inverse filter definition

Deconvolution (DECON) objective

Deconvolution Operator
Filter Parameter
of Deconvolution

Filter length
Gap length
Number of filters per
trace
Percent white noise to
add

Deconvolution Approaches
Decon is normally applied before stack (DBS). But it is sometimes is applied after
stack (DAS) The term deconvolution is most often applied to a type of inverse filtering.

a type of
deconvolution
often applied to
marine data.

corrects for inelastic


attenuation by
dividing the input into
relatively narrow
frequency bandwidths
and applying AGC
to each.

uses the redundancy


of multifold data to
statistically
determine and
attenuate effects on
signal waveform that
occur in the vicinity
of each source and
receiver position.

develops
mathematical
models for the source
wavelet, noise, and
the Q-effect.

Inverse Filtering Principles


Before
Decon

After
Decon

White
Spectrum

Inverse Filtering Principles

Deconvolution Summary

If decon were completely successful in


compressing the wavelet components and
attenuating multiples it would leave only
the reflectivity of the earth on the seismic
trace.

In so doing, vertical resolution is increased


and earth impulse response or reflectivity is
approximately recovered.

Deconvolution Results

References
Al-Sadi, Hamid N., 1980, Seismic Exploration, Technique
and Processing, Birkhliuser Verlag Basel, Germany
Gadallah, M., and Fisher, R., 2009, Exploration
Geophysics, USA.
Sheriff, Robert E., and Lloyd P. Geldart, 1995,
Exploration Seismology, Cambridge University Press,
USA.
Tellford, W.M., L.P. Geldart,and R.E. Sheriff, 1990,
Applied Geophysics, Second Edition, Cambridge
University Press, USA.

Thank You
Terima Kasih
Mauliate

You might also like