Lab Safety PWP

Lab Safety
General Safety Rules

1. Listen to or read instructions
carefully before attempting to do
anything.
2. Wear safety goggles to protect
your eyes from chemicals, heated
materials, or things that might be able
to shatter.
3. Notify your teacher if any spills or
accidents occur.

4. After handling chemicals, always
wash your hands with soap and
water.
5.
6.
During lab work, keep your hands

away from your face.
Tie back long hair.

7. Roll up loose sleeves.
8. Know the location of the fire
extinguisher, fire blanket, eyewash
station, and first aid kit.
9. Keep your work area uncluttered. Take
to the lab station only what is
necessary.

10. It is suggested that you wear
glasses rather than contact lenses.
11. Never put anything into your mouth
during a lab experiment.
12. Clean up your lab area at the
conclusion of the laboratory period.
13. Never horse around or play
practical jokes in the laboratory.
Glassware Safety
1.
Chipped or cracked glassware should

not be used. Show it to the teacher.
2. Broken glassware should not be
disposed of in a classroom trashcan.
There is a special glass disposal
container for it.
3. When pouring liquids into glassware,
make sure the container you are
pouring into is resting on a table at
least a hands breadth from the edge.
Glassware Safety
4. Pour down a glass stirring rod to prevent
liquids from splattering.
5. If a piece of glassware gets broken, do
not try to clean it up by yourself. Notify
the teacher.
6. When inserting glass tubing into a rubber
stopper, apply a lubricant like glycerin to
the glass and use a twisting motion.
Glassware Safety
7. Do not place hot glassware in water.
Rapid cooling may make it shatter.
Chemical Safety
1. Wear protective goggles and a lab
apron whenever heating or pouring
hazardous chemicals.
2. Never mix chemicals together unless
you are told to do so (and then only in
the manner specified).
3. Never taste any chemicals (you should
never taste anything in the lab).
Chemical Safety
4.
If you need to smell the odor of

a chemical, waft the fumes toward
your nose with one hand. Do not
put your nose over the container
and inhale the fumes.
5. Never pour water into a
concentrated acid. Acid
should be poured slowly into water.
Chemical Safety
6. Follow the instructions of your
teacher when disposing of all
chemicals.
7. Wash your hands after handling
hazardous chemicals.
Electrical Safety
1. Lay electrical cords where no
one can trip on them or get
caught in them.
2. Be sure your hands and your lab
area are dry before using
electrical equipment.
3. Never poke anything into
electrical outlets.
Electrical Safety
4. Unplug cords by pulling the plug
and not the cord.
5. Unplug all electrical equipment at
the end of the lab period.
Heating Safety
1. Let burners and hotplates cool
down before touching them. Test to
see if they are cool enough by
bringing the back of your hand
close to them.
2. Use tongs and/or protective gloves
to handle hot objects.
3. Never reach across an open flame
or burner.
Heating Safety
4. The only type of glassware that may
safely be heated is either Kimax or
Pyrex.
5. Always point the top ends of test tubes
that are being heated away from people.
6. When heating a test tube, move it
around
slowly over the flame to
distribute the
heat evenly.
Heating Safety
7. Only glassware that is thoroughly
dry should be heated.
8. Heat glassware by placing it on a
wire gauze platform on a ring stand.
Do not hold it in your hand.
Heating Safety
9. When lighting a burner, wait until the
striker is in place before you turn on the
gas.
10. The amount of air can be adjusted by
the air supply valve below the tube of
the burner. This regulates the flame
temperature and color.
11. Never leave a burner or hotplate
unattended.
First Aid
Injury:
Burns
What To Do:
Immediately flush with
cold water until burning
sensation is lessened.
First Aid
Injury:
Cuts, bruises
What To Do:
Do not touch an open wound
without safety gloves.
Pressing directly on minor cuts will stop
bleeding in a few minutes. Apply cold
compress to bruises to reduce swelling.
First Aid
Injury: Fainting
To Do: Provide fresh air and have the
person recline so that their head is
lower than the rest of their body.
First Aid
Injury:
Eyes
What To Do: Flush eyes immediately
with plenty of water for
several minutes. If a foreign object
is lodged in the eye, do not allow the
eye to be rubbed.
First Aid
Injury:
Poisoning
What To Do: Find out what substance
was responsible for the
poisoning and alert the
teacher immediately.
First Aid
Injury:
Spills on the skin
What To Do: Flush with large
quantities of water. For
acid spills, apply baking
soda
solution. For base
spills, apply
vinegar or
boric acid.
First Aid
Injury:
Electrical shock
What To Do: Shut off the current at
the source. Remove wire
with rubber gloves. Alert
the
teacher immediately.

Lab Safety PWP

Uploaded by

Copyright:

Available Formats

Lab Safety PWP

Uploaded by

Document Information

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

Lab Safety PWP

Uploaded by

Copyright:

Available Formats

Lab Safety

General Safety Rules

General Safety Rules

During lab work, keep your hands

General Safety Rules

General Safety Rules

Chipped or cracked glassware should

If you need to smell the odor of

You might also like