Scribd
Upload
497 views7 pages

Crystal Oscillator

A crystal oscillator uses a piezoelectric crystal, usually quartz, as a resonant circuit to provide very stable frequency control. The crystal vibrates at its natural resonant frequency when an alternating voltage is applied, due to the piezoelectric effect. Crystal oscillators are used where great stability is required, such as in communications equipment, as crystals have high Q-factors and stability. A basic crystal oscillator circuit connects the crystal in a feedback path of an amplifier such as a BJT or FET to excite it at its series resonance frequency.

Uploaded by

Paresh Sawant
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
497 views7 pages

Crystal Oscillator

A crystal oscillator uses a piezoelectric crystal, usually quartz, as a resonant circuit to provide very stable frequency control. The crystal vibrates at its natural resonant frequency when an alternating voltage is applied, due to the piezoelectric effect. Crystal oscillators are used where great stability is required, such as in communications equipment, as crystals have high Q-factors and stability. A basic crystal oscillator circuit connects the crystal in a feedback path of an amplifier such as a BJT or FET to excite it at its series resonance frequency.

Uploaded by

Paresh Sawant
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPT, PDF, TXT or read online on Scribd
You are on page 1/ 7

Crystal Oscillator

Quartz Crystal Resonators and Oscillators


For Frequency Control and Timing Applications

A Crystal

Oscillator is basically a tuned circuit Oscillator using a


piezoelectric crystal as a resonant circuit.

The crystal ( usually quartz) has a greater stability.


Crystal Oscillators are used whenever great stability is required, such
as communication transmitters and receivers.
Crystal has Electromechanical resonance, we can represent the Crystal
action by equivalent electrical circuit as shown

Piezoelectric Effect :
The quartz crystal is made of silicon oxide (SiO2) and exhibits a
property called the piezoelectric.
When a changing an alternating voltage is applied across the
crystal, it vibrates at the frequency of the applied voltage. In the
other word, the frequency of the applied ac voltage is equal to the
natural resonant frequency of the crystal.
The thinner the crystal, higher its frequency of vibration. This
phenomenon is called piezoelectric effect.
Crystal Material : Rochelle salt, Quartz & Tourmaline Exhibits
piezoelectric. property

Q-Factor
Describes how under-damped an oscillator or resonator is. OR
Characterizes a resonator's bandwidth relative to its center frequency.

The damping of a system can be described as following:


Overdamped: The system returns (exponentially decays) to equilibrium without
oscillating.
Critically damped: The system returns to equilibrium as quickly as possible without
oscillating.
Under-damped: The system oscillates (at reduced frequency compared to
the undamped case) with the amplitude gradually decreasing to zero.
Undamped: The system oscillates at its natural resonant frequency (o).

Characteristic of Quartz Crystal:


The crystal can have two resonant frequencies;
One is the series resonance frequency f1 which occurs when XL = XC. At this
frequency, crystal offers a very low impedance to the external circuit where Z =
R.
The other is the parallel resonance (or antiresonance) frequency f2 which occurs
when reactance of the series leg equals the reactance of C M. At this frequency,
crystal offers a very high impedance to the external circuit

R
L
C

CM

The crystal is connected as a series element in the feedback


path from collector to the base so that it is excited in the
series-resonance mode.

BJT
FET

Since, in series resonance, crystal impedance is the smallest that causes


the crystal provides the largest positive feedback.

Resistors R1, R2, and RE provide a voltage-divider stabilized dc bias


circuit. Capacitor CE provides ac bypass of the emitter resistor, RE to avoid
degeneration.

The RFC coil provides dc collector load and also prevents any ac signal
from entering the dc supply.

The coupling capacitor CC has negligible reactance at circuit operating


frequency but blocks any dc flow between collector and base.

The oscillation frequency equals the series-resonance frequency of the


crystal and is given by:

1
fo
2 LCC

You might also like