On Landslide

Wireless sensor
network for
landslide detection
BY
526 PRATHAMESH KANAVAJE
545 SOUMIL SHAH
INTRODUCTION
Natural disasters are increasing world wide due to the global
warming and climate change. The losses due to these
disasters are increasing in an alarming rate.
Hence, it is would be beneficial to detect the pre-cursors of
these disasters, early warn the population, evacuate them,
and save their life. However, these disasters are largely
unpredictable and occur within very short spans of time.
Wireless Sensors are one of the cutting edge technologies
that can quickly respond to rapid changes of data and send
the sensed data to a data analysis center in areas where
cabling is inappropriate.
Requirement Analysis
Analysis of Scenario
landslides induced rainfall
Selection of Geophysical Sensors
Placement of Geophysical Sensors
Spatial Distribution of the DEP (Deep Earth Probe)
Wireless Sensor Network Requirements
Algorithm Requirements
Network Requirements
Data Analysis Requirements
Data Visualization Requirements
Sensor
Wireless Sensor Network Architecture
Since the geological and hydrological properties

of each of the locations, of the landslide prone area,
differ with respect to the different regions they belong to
they are divided into region.
In this particular case, the deployment area is divided
into three regions such as crown region, middle region,
and toe region of the slope as shown in Figure 2, and
numerous WPs are deployed in these regions.
Wireless Network Designand Architecture
One of the important requirements for any landslide

detection system is the efficient delivery of data in near
real-time. This requires seamless connectivity with
minimum delay in the network.
Wireless Sensor Network Algorithms
Threshold based temporal data collection and data

aggregation method is designed and implemented for
effective data aggregation.
This algorithm combined with the newly designed state
transition algorithm contributes optimum energy
consumption by each node and in increasing the life time of
the whole network
Wireless Software Architecture

The existing Wireless Sensor Network (WSN) system for
landslide detection incorporates various heterogeneous
wireless networks such as the WSN, Wi-Fi, satellite network,
and broadband network. Each of these networks perform at
different frequency range, that contributes to different traffic
rate, congestion, data packet loss, buffering methods, delay,
and different data collection, transmission, and processing
methods.
This wireless software architecture includes wireless sensor
network software, wireless sensor gateway software, and a
middleware for heterogeneous wireless networks.
Design of Interfacing Sensors and

Power Management Methods
The special purpose interfacing circuit act as an
intermediary to remove the variance experienced between
the required input voltage for a data acquisition board and
the output voltage received from the geophysical sensors.
This power circuit board is designed with high efficiency
regulator chips to provide multiple outputs from a single
power battery input, a non-regulated 6Volts DC supplied
from rechargeable lead acid batteries. To increase the
lifetime of the lead acid batteries, they are automatically
recharged by the solar recharging unit using the charge
controller
Field Deployment Methods and Experiences
Approximately 15 landslide prone areas have been visited

and studied, that had historically experienced landslides.
After extensive investigation of the 15 sites, five sites were
identified as potential field deployment sites for a Wireless
Sensor
Network (WSN) in landslide monitoring applications.
Validationofthe Complete System -Landslide Warning

Issued
The decision for each level depends on the moisture(for an

Early warning), pore pressure (for warning), and movement
(for warning) sensor data values correlating with the rainfall
intensity. Along with the three level warning system, the
results of the landslide modeling software is compared to
avoid false alarms. Landslide modeling software
incorporates the raw sensor data from the field deployment
site, along with data from soil tests, lab setup , and other
terrain information to determine the Factor of Safety (FS)
Conclusion
Our researchers, at Amrita University, designed and deployed a Wireless

Sensor
Network for the purpose of landslide detection . The complete functional
system consists of 50 geological sensors and 20 wireless sensor nodes.
This network has the capability to provide real-time data through the
Internet and also to issue warnings ahead of time using the innovative
three level warning system developed. For two years it has been
gathering vast amounts of data, providing better understanding of
landslide scenario and has been poised to warn of any pertinent landslide
disaster in future. The system has proved its validity by delivering real
warning to the local community during heavy rains in the last monsoon
season (July 2009).

On Landslide

Uploaded by

Copyright:

Available Formats

On Landslide

Uploaded by

Document Information

Original Description:

Original Title

Copyright

Available Formats

Share this document

Share or Embed Document

Sharing Options

Did you find this document useful?

Is this content inappropriate?

Copyright:

Available Formats

On Landslide

Uploaded by

Copyright:

Available Formats

Wireless sensor

Wireless Sensor Network Architecture

Since the geological and hydrological properties

Wireless Network Designand Architecture

One of the important requirements for any landslide

Wireless Sensor Network Algorithms

Threshold based temporal data collection and data

Wireless Software Architecture

Design of Interfacing Sensors and

Field Deployment Methods and Experiences

Approximately 15 landslide prone areas have been visited

Validationofthe Complete System -Landslide Warning

The decision for each level depends on the moisture(for an

Our researchers, at Amrita University, designed and deployed a Wireless

You might also like