Scribd
Upload
954 views25 pages

NTPC Barh

The document summarizes information about the NTPC Barh Thermal Power Plant located in Bihar, India. The power plant has a total installed capacity of 3,300 MW split between multiple units of varying sizes. It receives coal from the Piparwar Mines in Jharkhand state via rail and uses a coal handling plant, boiler, steam turbine and generator to convert the heat energy from burning coal into electrical energy. Ash handling at the plant involves removing fly ash using fabric filters or electrostatic precipitators which can collect over 99% of ash particles from the flue gases.

Uploaded by

sweetysriti
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
954 views25 pages

NTPC Barh

The document summarizes information about the NTPC Barh Thermal Power Plant located in Bihar, India. The power plant has a total installed capacity of 3,300 MW split between multiple units of varying sizes. It receives coal from the Piparwar Mines in Jharkhand state via rail and uses a coal handling plant, boiler, steam turbine and generator to convert the heat energy from burning coal into electrical energy. Ash handling at the plant involves removing fly ash using fabric filters or electrostatic precipitators which can collect over 99% of ash particles from the flue gases.

Uploaded by

sweetysriti
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PPTX, PDF, TXT or read online on Scribd
You are on page 1/ 25

Submitted by: Priti Kumari

(0178ex111019)
About NTPC
NTPC, the largest power Company in India, was setup in
1975 to accelerate power development in the country.
NTPC has installed capacity of 29,394 MW.
It has 15 coal based power stations (23,395 MW)
7 gas based power stations (3,955 MW)
4 power stations in Joint Ventures (1,794 MW).
The company has power generating facilities in all
major regions of the country.
It plans to be a 75,000 MW company by 2017.

NTPC super Thermal power
plant,Barh
INTRODUCTION OF THERMAL
POWER PLANT,BARH
The stage-1 of NTPC barh was established in 1999
The stage-2 of NTPC barh was established in 2006
It is located barely four kilometres east of the Barh sub-
division on National Highway-31
The first three unit are of 1,980MW
The other two unit are of 1,320MW
Total generation capacity is 3,300MW
Favourable condition
Abundant quantity of clean cooling water
Good transportation facility
INSTALLED CAPACITY
STAGE UNIT
NUMBER
INSTALLED
CAPACITY(M
W)
DATE OF
COMISSIONI
NG
STATUS
2ND 1 660 OCTOBER
2013
Pending
2ND 2 660 JULY 2014 Scheduled
1ST 1 660 DECEMBER
2014
Scheduled
1ST 2 600 2015 JUNE Scheduled

1ST 3 600 2015
DECEMBER
Scheduled

TOTAL 5 3330
Main Parts Of Barh Thermal Power
Plant
Principle
Layout
Coal Handling Plant
Boiler
Super Heater
Steam Turbine
Economiser
Generator
Water Treatment Plant
Ash Handling Plant
Control Room
Basic principle of thermal power
plant
A generating station which converts heat energy of coal combustion into
electrical energy is known as a steam power station.
Steam is produced in the boiler by utilizing the heat of coal combustion. The
steam is then expanded in the steam turbine and is condensed in a condenser to
be fed into the boiler again. The steam turbine drives the alternator which
converts mechanical energy of the turbine into electrical energy.
Basic structure of power plant
Coal Handling Plant Details
Source of coal = Piparwar Mines North Karanpur
(Jharkhand)
Location = Near Ranchi
Distance = 1200 Kms.
Type of coal=f-grade(Washed) E-grade(raw)
Coal requirement=13,000MT/Day(04 rakes)




Ash Handling Technique
A natural result from the burning of fossil fuels,
particularly coal, is the emission of flyash. Ash is mineral
matter present in the fuel. For a pulverized coal unit, 60-
80% of ash leaves with the flue gas.
Two emission control devices for flyash are the fabric
filters and electrostatic precipitators.
Electrostatic precipitators have collection efficiency of
99%, but do not work well for flyash with a high electrical
resistivity (as commonly results from combustion of low-
sulfur coal). In addition, the designer must avoid allowing
unburned gas to enter the electrostatic precipitator since
the gas could be ignited.

You might also like