Powders

A Pharmaceutical powder is a mixture of finely divided drugs or chemicals in a dry form meant for internal or external use. Advantages of powders : 1-flexibility of compounding. 2-Good chemical stability 3-Rapid dispersion of ingredients (because of small particle size

Disadvantage of powders:
1-Time-consuming preparation 2-Inaccuracy of dose( size of measuring spoon, density of powder, humidity, degree of settling , fluffiness. 3-Unsuitability for many unpleasant tasting, hygroscopic and deliquescent drugs

Mixing of powders
Large-Scale Mixing Equipment

The ideal mixer should 1- produce a complete blend rapidly to avoid

product damage.
2- It should be cleaned and discharged easily 3- be dust-tight

4 require low maintenance and low power

consumption.

Small-Scale Mixing Equipment

1- Mortar and pestle

* The pharmacist most generally employs the mortar and pestle for the small-scale mixing * The mortar and pestle method is a single operation. Thus, it is particularly useful where some degree of particle-size reduction

as well as mixing is required as in the case of mixtures of

crystalline material.
4

Morters are prepared usually from Wedgwood ware, porcelain or glass.

A- Glass mortars: * Are designed primarily for use in preparing solutions and suspensions of chemical materials in a liquid. Also are suitable for Preparing ointments * Glass has advantage of being comparatively nonporous and of not staining easily and thus is particularly useful when-substances such as flavoring oils or highly colored substances are used. Glass cannot be used for comminuting hard solids.
5

B- Wedgwood mortars
Are suited for comminution of crystalline solids. * Wedgwood is relatively porous and will stain quite easily. A Wedgwood mortar is available with a roughened interior which aids in the comminution process but requires care in washing since particles of the drugs may be trapped in the rough surface and cause contamination.

C- Porcelain mortars
are very similar to Wedgwood, except that the exterior surface of the former is usually glazed and thus less porous.

Pestles
* Are made of the same material as the mortar. * Pestles made entirely of porcelain are objectionable, because they are broken easily. Pestles and mortars should not be interchanged.

* The efficiency of the grinding or mixing operation depends largely on a maximum contact between the surfaces of the head of the pestle and the interior of the mortar

Small-Scale Mixing Equipment

2- Spatulation
The blending of powders with a spatula on a tile or paper used sometimes for small quantities or when the mortar and pestle technique is undesirable.
It is not suitable for large quantities of powders or for powders containing one or more potent substance because homogenous blending may not occur.
9

Small-Scale Mixing Equipment

3- Sieving
Sieving usually is employed as a pre-or post-mixing method to reduce loosely held agglomerates and to increase the overall effectiveness of blending process.

10

Extemporaneous Techniques
1. Use of geometric dilution for the incorporation of small amounts of potent drugs 2. Reduction of particle size of all ingredients to the same range. 3. Sieving when necessary to achieve mixing or reduction of agglomerates, especially in powders into which liquids have been incorporated. 4. Heavy trituration, when applicable, to reduce the bulkiness of a powder. 5. Protection against humidity, air oxidation and loss of volatile ingredients.
11

Powders are prepared most commonly either as: 1- Divided powders and bulk powders which are mixed with water prior to administration 2- Dusting powders which are applied locally. 3- Dentifrices 4- Insufflations
12

Extemporaneous Techniques( cont. )

The manually operated procedures are trituration, pulverization by intervention and levigation. 1- Trituration: is used to comminute( reduce particle size) & to mix powders. 1-A porcelin preferred than glass morter. 2- A glass morter is preferrable for chemicals that stain a porcelin. When granular or crystalline materials are to be incorporated in to powdered product ,these materials are comminuted individually and then blended together in the morter.

13

2- Pulverization by Intervention Substance are reduced& subdivided with an additional material ( i.e solvent) that can be removed easily after pulverization is complete. * This technique is applied to Substances which are gummy and tend to reagglomerate or which resist grinding. As camphor which is gummy, so addition of alcohol or other volatile solvent can be reduced readily to a fine powder. Similarly, iodine crystals may be comminuted with the aid of ether. In both instances the solvent is permitted to evaporate and the powdered material is recovered

14

3- Levigation
In this process A- paste is first formed by the addition of a suitable non solvent to the solid material. B-Particle-size reduction then accomplished by rubbing the paste in a mortar with a pestle or on an ointment slab using a spatula.
15

Divided Powders
Are dispensed in the form of individual doses and generally are dispensed in papers, properly folded (chartulae). They also may be dispensed in metal foil, small heatsealed plastic bags or other containers.
16

Divided Powders
- After weighing, comminuting and mixing the ingredients, the powders must be divided accurately into the prescribed number of doses. In order to achieve accuracy consistent with the other steps in the preparation, each dose should be weighed individually and transferred to a powder paper. Following completion of this step the powder papers are folded.
17

Powder Papers
- Four basic types of powder papers are available. 1. Vegetable parchment, a thin semiopaque moisture-resistant paper. 2. White bond, an opaque paper with no moisture-resistant properties. 3. Glassine, a glazed, transparent moistureresistant paper. 4. Waxed, a transparent waterproof paper.

18

Powder Papers
Hygroscopic and volatile drugs can be protected best by using a waxed paper, double-wrapped with a bond paper to improve the appearance of the completed powder. Parchment and glassine papers offer limited protection for these drugs.
19

Special Problems
1-Volatile Substances - The loss by volatilization may be prevented or retarded by use of heat-sealed plastic bags or by double wrapping with a waxed or glassine paper inside of a bond paper.

20

Special Problems
2-Eutectic Mixtures
Liquids result from the combination of phenol, camphor, menthol, thymol, antipyrine, phenacetin, acetanilid, aspirin, salol and related compounds at ordinary temperatures. These so-called eutectic mixtures may be incorporated into powders by addition of an inert diluent. Magnesium carbonate or light magnesium oxide are used commonly and effective diluents for this purpose, although kaolin, starch, bentonite and other absorbents have been recommended.
21

Special Problems( cont )

3-Liquids In small amounts, liquids may be incorporated into divided powders. Magnesium carbonate, starch or lactose may be added to Increase the absorbability of the powders if necessary. When the liquid is a solvent for a nonvolatile heat-stable compound, it may be evaporated gently on a water bath. Lactose may be added during the course of the evaporation to increase the rate of solvent loss by increasing the surface area.

22

Special Problems( cont )

4-Hygroscopic and Deliquescent Substances Substances that become moist because of affinity for moisture in the air may be prepared as divided powders by adding inert diluents. Double-wrapping is desirable for further protection. Extremely deliquescent compounds cannot be prepared satisfactorily as powders.

23

Bulk Powders
may be classified as oral powders, dentifrices, douche powders, dusting powders, insuffiations and triturations. Oral Powders - These generally are supplied as finely divided powders or effervescent granules.The finely divided powders are intended to be suspended or dissolved in water or mixed with soft foods, e.g, applesauce, prior to administration. Antacids and laxative powders frequently are administered in this form

24

Effervescent granules
* Contain sodium bicarbonate and either citric acid, tartaric acid or sodium biphosphate in addition to the active ingredients. * On solution in water, carbon dioxide is released as a result of the acid-base reaction. The effervescence from the release of the carbon dioxide serves to mask the taste of salty or bitter medications. * The completed product must be dispensed in tightly closed glass containers to protect it against the humidity of the air.

25

Effervescent powders
- Other preparative techniques have been reported for effervescent powders such as a fluidized-bed procedure in which the powders are blended and then suspended in a stream of air in a Wurster chamber. Water is sprayed into the chamber resulting in a slight reaction and an expansion of the particles to form granules ranging in size from 10to 30-mesh.

26

Effervescent powders

This approach apparently offers a number of advantages over the older techniques. The extent of reaction and particle size are controlled during the manufacture. A drying oven, trays and even grinding devices are not required. Furthermore, the technique lends itself to a continuous as well as a batch operation.
27

Dentifrices

These may be prepared in the form of a bulk powder, generally containing a soap or detergent, mild abrasive and an anticariogenic agent.

28

Douche Powders

These products are completely soluble and are intended to be dissolved in water prior to use as antiseptics or cleansing agents for a body cavity. They most commonly are intended for vaginal use, although they may be formulated for nasal, otic or ophthalmic use. Generally, since aromatic oils are included in these powders.

Dispensing in wide-mouth glass jars serves to protect against loss of volatile materials and permits easy access by the patient

29

Dusting Powders
-

These are locally applied nontoxic preparations that are intended to have no systemic action. They always should be dispensed in a very fine state to enhance effectiveness and minimize irritation. Extemporaneously prepared should be dispensed in sifter-top packages. Commercial powders are available in sifter-top containers or pressure aerosols. The latter, more expensive than the other containers, offer the advantage of protection from air, moisture and contamination, as well as convenience of application.

30

Dusting Powders

Dusting powders are applied to various parts of the body as lubricants, protectives, absorbents, antiseptics, antipruritics, anti bromhidrosis agents, astringents and antiperspirants.

31

Insufflations
- These are finely divided powders introduced into body cavities such as the ears, nose, throat, tooth sockets and vagina. An insufflator (powder blower) usually is employed to administer these products.

32

Insufflations

However, the difficulty in obtaining a uniform dose has restricted their general use. Specialized equipment has been developed for the administration of micronized powders of relatively potent drugs. The Norisodrine Sulfate Aerohaler Cartridge (Abbott) is an example.

33

In the use of this Aerohaler, inhalation by the patient causes a small ball to strike a cartridge containing the drug. The force of the ball shakes the proper amount of the powder free, permitting its inhalation. Another device, the Spin haler turbo-inhaler (Fisons), is a propeller-driven device designed to deposit a mixture of lactose and micronized cromolyn sodium into the lung as an aid in the management of bronchial asthma.
34

Triturations
-

These are dilutions of potent powdered drugs, prepared by intimately mixing them with a suitable diluent in a definite proportion by weight. They were at one time official as 1 to 10 dilutions. The pharmacist sometimes prepares triturations of poisonous substances, eg, atropine, in a convenient concentration using lactose as the diluent, for use at the prescription counter.

35

Triturations
The correct procedure for preparing such triturations or any similar dilution of a potent powder medicament, to insure uniform distribution of the latter, is: 1- Reduce the drug to a moderately fine powder in a mortar. 2-Add about an amount of diluents & mix well by thorough trituration in the mortar. 3-Successively add portions of diluent ,triturating after each addition ,until the entire quantity of diluent has been incorporated. Under no circomostances should the entire quantity of of diluent be added at once to the drug that is to be diluted, ununiform dispersion will be achieved
36