Scribd
Upload
4 views1 page

Euro Code Provisions-Constants

The document outlines the design values for material coefficients including modulus of elasticity, shear modulus, Poisson's ratio, and coefficient of thermal expansion. It specifies notch toughness requirements at various temperatures and special requirements for reduction of area. Additionally, it details treatment conditions and steel grade designations along with yield and ultimate strength values for different thicknesses and grades of steel.

Uploaded by

arunkumar.mgs
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
4 views1 page

Euro Code Provisions-Constants

The document outlines the design values for material coefficients including modulus of elasticity, shear modulus, Poisson's ratio, and coefficient of thermal expansion. It specifies notch toughness requirements at various temperatures and special requirements for reduction of area. Additionally, it details treatment conditions and steel grade designations along with yield and ultimate strength values for different thicknesses and grades of steel.

Uploaded by

arunkumar.mgs
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Design values of material coefficients

2
Modulus of elasticity E 210000 N/mm
Shear modulus E/2(1+n) G 80769.23
Poisson's ratio n 0.3
a
o
Coefficient of thermal expansion 1.20E-05 / C

Notch toughness
o
JR 20 C Min. 27 J
o
J0 0 C Min. 27 J
o
J2 -20 C Min. 27 J
o
K2 -20 C Min. 40 J

Special requirement
Z15 min. 15% reduction of area
Z25 min. 25% reduction of area
Z35 min. 35% reduction of area

Treatment conditions
+M thermomechanical rolling
+N normalised rolling
+AR as rolled

Steel Grade Designation


EN 10025-2 2019 S235 J2 Z25 +M

fy & fu
Thickness 16 mm
Grade S355
fy 355 MPa
fu 490 MPa

fy fu
EN 1993-1-1: 2005
S235 S275 S355 S450 S235 S275
0 <t≤ 40 235 275 355 440 360 430
40 <t≤ 80 215 255 335 410 360 410

fy & fu
Thickness 65 mm
Grade S355
fy 325 MPa
fu 470 MPa

fy fu (Not for less than 3m


EN10025-2: 2019
S235 S275 S355 S460 S500 S235
0 <t≤ 16 235 275 355 460 500 360
16 <t≤ 40 225 265 345 440 480 360

You might also like