Scribd
Upload
3 views1 page

MX SW Programming Manual

This document provides instructions for programming the MX-S(M)-SW series square wave controllers, which operate at voltages between 24V-48V or 24V-60V. It outlines the steps to connect the controller to a Windows PC, download configuration settings, modify parameters such as current and speed, and save the changes. Additionally, it explains the voltage selection options for the 60V controller and how to change the motor's rotation direction.

Uploaded by

cyborg6285
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
3 views1 page

MX SW Programming Manual

This document provides instructions for programming the MX-S(M)-SW series square wave controllers, which operate at voltages between 24V-48V or 24V-60V. It outlines the steps to connect the controller to a Windows PC, download configuration settings, modify parameters such as current and speed, and save the changes. Additionally, it explains the voltage selection options for the 60V controller and how to change the motor's rotation direction.

Uploaded by

cyborg6285
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

This is for MX-S(M)-SW series controllers, which is square wave controller, voltage from 24V-48V or 24V-60V.

After installation of the programming software, and run the software, you may get a window
similar to the following image:

1. connect the controller to windows pc via the programming USB cable, and run the software,
you will see a similar software window as the above image.
2. Connect the controller to software buy connect the command column button Connect, on the
left bottom you may see a message of “connect success”, some time it does show, just forget it
and go to next step 3.
3. Connect the command column button GetConfig, the controller setting will be download to
the window and you can also see the “getconfig success”
4. Now you can change the setting data as per you request: like current, voltage, speed, motor
runing direction and so on.
5. After the reset is finished, connect the store/save button and the data will be written to the
controller. Close the window or Exit button and finish the programming.

Special explain the voltage option for 60v controller. If you select 24v, the controller will work
with 24v to 60v battery, if you choose 36v, the controller will work with 36v to 60v battery, and if
you choose 48v, the controller will work with 48v to 60v battery.

FWD REV can change the motor default rotation direction.

You might also like