Scribd
Upload
3 views1 page

Thank 5

The document describes an Arduino sketch that demonstrates the use of an array to control multiple LEDs connected to non-contiguous pins. It initializes the pins as outputs and lights the LEDs in sequence, first from the lowest to the highest pin and then in reverse. The code includes a timer to control the speed of the LED lighting sequence.

Uploaded by

yehtutoo246
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
3 views1 page

Thank 5

The document describes an Arduino sketch that demonstrates the use of an array to control multiple LEDs connected to non-contiguous pins. It initializes the pins as outputs and lights the LEDs in sequence, first from the lowest to the highest pin and then in reverse. The code includes a timer to control the speed of the LED lighting sequence.

Uploaded by

yehtutoo246
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as TXT, PDF, TXT or read online on Scribd
You are on page 1/ 1

/*

Arrays

Demonstrates the use of an array to hold pin numbers in order to iterate over
the pins in a sequence. Lights multiple LEDs in sequence, then in reverse.

Unlike the For Loop tutorial, where the pins have to be contiguous, here the
pins can be in any random order.

The circuit:
- LEDs from pins 2 through 7 to ground

created 2006
by David A. Mellis
modified 30 Aug 2011
by Tom Igoe

This example code is in the public domain.

https://docs.arduino.cc/built-in-examples/control-structures/Arrays/
*/

int timer = 100; // The higher the number, the slower the timing.
int ledPins[] = {
2, 7, 4, 6, 5, 3
}; // an array of pin numbers to which LEDs are attached
int pinCount = 6; // the number of pins (i.e. the length of the array)

void setup() {
// the array elements are numbered from 0 to (pinCount - 1).
// use a for loop to initialize each pin as an output:
for (int thisPin = 0; thisPin < pinCount; thisPin++) {
pinMode(ledPins[thisPin], OUTPUT);
}
}

void loop() {
// loop from the lowest pin to the highest:
for (int thisPin = 0; thisPin < pinCount; thisPin++) {
// turn the pin on:
digitalWrite(ledPins[thisPin], HIGH);
delay(timer);
// turn the pin off:
digitalWrite(ledPins[thisPin], LOW);
}

// loop from the highest pin to the lowest:


for (int thisPin = pinCount - 1; thisPin >= 0; thisPin--) {
// turn the pin on:
digitalWrite(ledPins[thisPin], HIGH);
delay(timer);
// turn the pin off:
digitalWrite(ledPins[thisPin], LOW);
}
}

You might also like