Scribd
Upload
2 views1 page

PLC Assignment-2 (SemI)

The document outlines an assignment for the course McE-31022: Programmable Logic Controller I at the Technological University (Mandalay). It includes questions related to ladder programming, such as controlling a light bulb with start and stop switches, ensuring safety with simultaneous switch activation, and operating a motor with two normally open switches. Students are required to draw ladder diagrams and logical symbols for the specified scenarios.

Uploaded by

minhaeyoon3997
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
2 views1 page

PLC Assignment-2 (SemI)

The document outlines an assignment for the course McE-31022: Programmable Logic Controller I at the Technological University (Mandalay). It includes questions related to ladder programming, such as controlling a light bulb with start and stop switches, ensuring safety with simultaneous switch activation, and operating a motor with two normally open switches. Students are required to draw ladder diagrams and logical symbols for the specified scenarios.

Uploaded by

minhaeyoon3997
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

McE-31022:Programmable Logic Controller I

MINISTRY OF SCIENCE AND TECHNOLOGY


DEPARTMENT OF ADVANCED SCIENCE AND TECHNOLOGY
TECHNOLOGICAL UNIVERSITY (MANDALAY)
Department of Mechatronic Engineering
2023-2024 Academic Year
Fourth Year (MC) Assignment II
McE-31022: Programmable Logic Controller I
This question included 1 page.
Attempt all questions.

Describes the following questions with the ladder program.


1. A light bulb is switched on by pressing start switch, and the bulb remains on until another
stop switch is pressed. (Mitsubishi Notation)
2. For safety reasons, machines are often set up to ensure that a machine can only be operated
by the operator pressing two switches simultaneously, one by the right hand and one by the
left hand. This is to ensure that both the operator’s hands will be on the switches and cannot
be in the machine when it is operating. Draw a ladder rung for such a requirement.
3. Two switches are normally open and both have to be closed for a motor to operate.
4. Draw the ladder diagram and logical symbol diagram for the following functional block
diagram.

*************** END OF QUESTION ***************

Page 1 of 1

You might also like