Scribd
Upload
5 views2 pages

Assignment 9

This document is an assignment for the course AML151 Engineering Mechanics, detailing tasks related to beam loading and analysis. Students are required to find reactions, draw axial force, shear force, and bending moment diagrams for various beam configurations. The assignment is due on June 30, 2021, and is worth a maximum of 10 marks.

Uploaded by

gameboy10t
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
5 views2 pages

Assignment 9

This document is an assignment for the course AML151 Engineering Mechanics, detailing tasks related to beam loading and analysis. Students are required to find reactions, draw axial force, shear force, and bending moment diagrams for various beam configurations. The assignment is due on June 30, 2021, and is worth a maximum of 10 marks.

Uploaded by

gameboy10t
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 2

DEPARTMENT OF APPLIED MECHANICS

Course: AML151 Engineering Mechanics


Assignment # 09
Date of Display: 23.06.2021 Maximum Marks: 10
Date of Submission: 30.06.2021 Instructors: Dr. Sachin Bakre & Dr. Sonal Dhanvijay

1) A beam is loaded as shown in Fig.1. Find the reactions at A and B. Also draw the axial
force diagram, shear force diagram and bending moment diagram.

Fig. 1
2) Draw the shear and moment diagrams for the cantilever beam subjected to the
combination of distributed and point loads as shown in Fig. 2. State the distance b to
the left of A where the bending moment is zero.

Fig. 2
3) Plot the shear and moment diagrams for the beam loaded as shown in Fig. 3. State the
maximum magnitudes of the shear force and bending moment for the beam.

Fig. 3

Page 1 of 2
4) Draw the shear force and bending moment diagram of the beam AB loaded through the
attached strut, shown in Fig. 2.

Fig. 4
5) Draw the torque diagram for the shaft as shown in Fig.5.

Fig. 5
****************

Page 2 of 2

You might also like