The document presents a series of problems related to CSMA/CD networks, including calculations for minimum frame sizes and packet sizes based on given parameters such as bandwidth, signal speed, and propagation delay. It also discusses scenarios involving collisions and back-off protocols between two stations on an Ethernet segment. The problems require understanding of network transmission dynamics and collision resolution techniques.
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
0 ratings0% found this document useful (0 votes)
13 views1 page
CSMA CD Numerical
The document presents a series of problems related to CSMA/CD networks, including calculations for minimum frame sizes and packet sizes based on given parameters such as bandwidth, signal speed, and propagation delay. It also discusses scenarios involving collisions and back-off protocols between two stations on an Ethernet segment. The problems require understanding of network transmission dynamics and collision resolution techniques.
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 1
1.
In a CSMA / CD network running at 1 Gbps over 1 km
cable with no repeaters, the signal speed in the cable is 200000 km/sec. What is minimum frame size? 2. A 2 km long broadcast LAN has 107 bps bandwidth and uses CSMA / CD. The signal travels along the wire at 2 x 108 m/sec. What is the minimum packet size that can be used on this network? 3. A and B are the only two stations on Ethernet. Each has a steady queue of frames to send. Both A and B attempts to transmit a frame, collide and A wins first back off race. At the end of this successful transmission by A, both A and B attempt to transmit and collide. The probability that A wins the second back off race is ___ . 4. Suppose nodes A and B are on same 10 Mbps Ethernet segment and the propagation delay between two nodes is 225 bit times. Suppose A and B send frames at t=0, the frames collide then at what time, they finish transmitting a jam signal. Assume a 48 bit jam signal. 5. Suppose nodes A and B are attached to opposite ends of the cable with propagation delay of 12.5 ms. Both nodes attempt to transmit at t=0. Frames collide and after first collision, A draws k=0 and B draws k=1 in the exponential back off protocol. Ignore the jam signal. At what time (in seconds), is A’s packet completely delivered at B if bandwidth of the link is 10 Mbps and packet size is 1000 bits.