0% found this document useful (0 votes)
8 views1 page

Linux Software RAID Lab

This document provides a step-by-step guide to setting up a Linux Software RAID 1 configuration using Kali Linux. It includes instructions for creating partitions on two disks, installing the mdadm tool, and verifying the RAID setup. The final steps involve creating a mount directory and formatting the RAID device for use.

Uploaded by

ellonequistis95
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
8 views1 page

Linux Software RAID Lab

This document provides a step-by-step guide to setting up a Linux Software RAID 1 configuration using Kali Linux. It includes instructions for creating partitions on two disks, installing the mdadm tool, and verifying the RAID setup. The final steps involve creating a mount directory and formatting the RAID device for use.

Uploaded by

ellonequistis95
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

Linux Software RAID Lab

1. Start and login to your Kali Linux virtual machine as user kali with a password of kali.

2. Enter sudo lsblk --scsi to list SCSI disk block devices. You should see sda, sdb, and sdc disk
devices. These are three separate disks. We will create a disk mirror between sdb and sdc.

3. Enter sudo fdisk /dev/sdb and press ENTER. Press n (new partition), and then press ENTER four
times to create a primary partition that consumes the entire disk.

4. Press t to change the partition type, and then enter fd to set the type to Linux raid autodetect.

5. Press w to write the changes to disk.

6. Repeat steps 4–6 in this exercise, except enter sudo fdisk /dev/sdc instead of sudo fdisk
/dev/sdb.

7. Enter sudo fdisk -l /dev/sdb /dev/sdc to verify that the Linux RAID autodetect partition flag has
been set on both disk partitions (look under the Type heading). Notice the partitions are /dev/sdb1 and
/dev/sdc1 (look under the Device heading).

8. Install the mdadm software RAID tool by typing sudo apt-get install mdadm.

9. Create a software RAID 1 (mirroring) configuration by typing sudo mdadm --create /dev/md1 --
level=1 --raid-devices=2 /dev/sdb1 /dev/sdc1. Take note of the double dashes (--) before the reate and
raid-devices parameters.

10. Press y (for yes, to continue creating the array).

11. Verify your work by typing sudo mdadm --detail /dev/md1. In the bottom right under the State
column you should see “active sync” for each of the mirrored disk partitions /dev/sdb1 and /dev/sdc1.

12. Make a mount directory by typing sudo mkdir /cust_trans.

13. Format the file system by typing sudo mkfs -t ext4 /dev/md1. Mount the file system to a
directory so it is ready to use by typing sudo mount /dev/md1 /cust_trans. Files can now be added to
the /cust_trans folder as you normally would with any folder, the difference is that now a copy of each
file will be mirrored to a second disk partition.

14. Enter the following command to verify the /cust_trans mount point is using the disk mirror
device /dev/md1: sudo mount | grep /dev/md1

You might also like