Scribd
Upload
52 views1 page

Aquitest

The document outlines a constant discharge test conducted on a single well to determine aquifer parameters. Key details include an unconfined aquifer with a saturated thickness of 60 m, a well radius of 0.4 m, and a constant discharge rate of 0.03 m3/s. The test aims to calculate pertinent aquifer parameters using appropriate pumping test methods, including the b value for the pumping well at 70 m.

Uploaded by

Abdilbasit Hamid
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
52 views1 page

Aquitest

The document outlines a constant discharge test conducted on a single well to determine aquifer parameters. Key details include an unconfined aquifer with a saturated thickness of 60 m, a well radius of 0.4 m, and a constant discharge rate of 0.03 m3/s. The test aims to calculate pertinent aquifer parameters using appropriate pumping test methods, including the b value for the pumping well at 70 m.

Uploaded by

Abdilbasit Hamid
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 1

Using the following data determine the aquifer parameters using constant discharge test.

1) It is a test in a single well where observation is made in the same well.


2) The saturated thickness of the aquifer is 60 m. The radius is 0.33 m and the well
radius is 0.4 m. The total well length up to the static water level is 70 m. The
aquifer is unconfined.
3) The screened section of the wells (L) is 60 m.
4) The constant discharge rate is 0.03 m3/s.
5) Give the b value for the pumping well 70 m.
6) The ground altitude is 2000 m.
7) Determine the pertinent aquifer parameters using all appropriate pumping test
methods.

You might also like