Scribd
Upload
9 views4 pages

Arduino Programacion

The document contains multiple Arduino sketches that control output pins for various LEDs. Each sketch sets up different pin configurations and includes loops that alternate the states of the pins with specified delays. The sketches demonstrate different patterns of turning the outputs on and off, utilizing both simultaneous and sequential control.

Uploaded by

pinponp120
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
9 views4 pages

Arduino Programacion

The document contains multiple Arduino sketches that control output pins for various LEDs. Each sketch sets up different pin configurations and includes loops that alternate the states of the pins with specified delays. The sketches demonstrate different patterns of turning the outputs on and off, utilizing both simultaneous and sequential control.

Uploaded by

pinponp120
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOCX, PDF, TXT or read online on Scribd
You are on page 1/ 4

const int elizabeth =1;

const int melani =3;

const int lisabel=5;

const int beiza =7;

void setup() {

pinMode(elizabeth, OUTPUT);

pinMode(melani, OUTPUT);

pinMode(lisabel, OUTPUT);

pinMode(beiza, OUTPUT);

void loop() {

digitalWrite(elizabeth, HIGH);

digitalWrite(melani, HIGH);

digitalWrite(lisabel, LOW);

digitalWrite(beiza, LOW);

delay(3000);

digitalWrite(elizabeth, LOW);

digitalWrite(melani, LOW);

digitalWrite(lisabel, HIGH);

digitalWrite(beiza, HIGH);

delay(2000);

const int elizabeth=0;


const int melani=4;

const int lisabel=8;

const int beiza=12;

void setup() {

pinMode(elizabeth, OUTPUT);

pinMode(melani, OUTPUT);

pinMode(lisabel, OUTPUT);

pinMode(beiza, OUTPUT);

void loop() {

digitalWrite(elizabeth, HIGH);

delay(1000);

digitalWrite(elizabeth, LOW);

digitalWrite(melani, HIGH);

delay(1000);

digitalWrite(melani, LOW);

digitalWrite(lisabel, HIGH);

delay(1000);

digitalWrite(lisabel, LOW);

digitalWrite(beiza, HIGH);

delay(1000);

digitalWrite(beiza, LOW);

const int neiza1=0;

const int neiza2=3;


const int neiza3=6;

const int neiza4=9;

void setup() {

pinMode(neiza1, OUTPUT);

pinMode(neiza2, OUTPUT);

pinMode(neiza3, OUTPUT);

pinMode(neiza4, OUTPUT);

void loop() {

digitalWrite(neiza1, HIGH);

digitalWrite(neiza2, HIGH);

digitalWrite(neiza3, HIGH);

digitalWrite(neiza4, HIGH);

delay(5000);

digitalWrite(neiza1, LOW);

digitalWrite(neiza2, LOW);

digitalWrite(neiza3, LOW);

digitalWrite(neiza4, LOW);

delay(1000);

You might also like