EE-226 Circuit Analysis-II

Problem Set 3

Instructor: Dr. Ghulam Mustafa Due Date: April 27, 2021

Problem 1. CLO1
The switch in the circuit seen in Figure 1 has been in position a for a long time before moving instantaneously to position
b at t = 0.
(a) Construct the s-domain equivalent circuit for t > 0.
(b) Find V1 and v1 .
(c) Find V2 and v2 .

Figure 1

Problem 2. CLO1
The switch in the circuit seen in Figure 2 has been closed for a long time before opening at t = 0. Use the Laplace
transform method of analysis to find v0 .

Figure 2

Problem 3. CLO1
The operational amplifier in the circuit in Figure 3 is ideal.
(a) Find the numerical expression for the transfer function H(s) = V0 /Vg .
(b) Give the numerical value of each zero and pole of H(s).

Page 1 of 3
 of H(s).
(b)

Problem Set 3 (Continued)

Figure P13.54
H(s) = VJV, for the
2(a). C? = 25 nF
H(s) = V0/Vt for the
2(b).
ts that have the trans-
JV-, = s/(s + 10,000). lkQ 200nF
^vw }|—
rom Appendix H and ft
+ c

Figure 3
13.55 The operational amplifier in the circuit in Fig. PI3.55
Problem 4. CLO1
is in
The op amp in the circuit seen ideal.
Figure 4 is ideal.
a)V0Find
(a) Find the transfer function /Vg . the numerical expression for the transfer
(b) (b) Find v0 if vg = 0.6u(t) V. function//(5) = VJVr
b) Give
(c) Find the steady-state expression forthe
vo ifnumerical
vg = 2 cos 10,value
000t V.of each zero and pole
of H(s).
H(s) = V()/V, for the
53. Identify the poles
function. Figure P13.55
m Appendix H which 400 pF
ig. P13.53 will result in
o poles that are distinct
values of the poles.
m Appendix H which
Fig. PI3.53 will result
two poles, both with
he value of the poles.
m Appendix H which Figure 4
Fig. P13.53 will result
h two Problem
poles that
5. are
x numbers. Calculate
[CLO6] Assume the line-to-neutral voltage Vo in the 60 Hz circuit of Figure 5 is 120 0◦ V (rms). Load Ra is absorbing
1200 W; load Rb is absorbing 1800 W; and load Xa is absorbing 350 magnetizing VAR. The inductive reactance of the
line (X1) is 1Ω. Assume Vg does not change after the switch opens.
(a) Calculate the initial value of i2 (t) and io (t).
13.56 The operational amplifier in the circuit in
(b) Find Vo , vo (t), and vo (0+ ) using the s-domain circuit of Figure 6.
(c)
Fig. PI3.56 is ideal.
Test the steady-state component of vo using phasor domain analysis.
(d) Using a computer programa) ofDerive theplot
your choice, numerical
vo vs. t forexpression
0 ≤ t ≤ 20ms. of the trans-
fer function H(s) = VJVg for the circuit in
Fig. P13.56.
b) Give the numerical value of each pole and zero
of H(s).

Page 2 of 3
Problem Set 3 (Continued)

Figure 5

Figure 6

Page 3 of 3