Scribd
Upload
9 views4 pages

Design Circuit Using Electro Pneumatic

The document outlines a lab module for the course MDJ20303, focusing on Basic Electro Pneumatic systems at Universiti Malaysia Perlis. It includes objectives, tools, and tasks for students to analyze and assemble pneumatic circuits. The lab aims to enhance students' understanding of designing and operating electro-pneumatic circuits.

Uploaded by

muhammad981120
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
9 views4 pages

Design Circuit Using Electro Pneumatic

The document outlines a lab module for the course MDJ20303, focusing on Basic Electro Pneumatic systems at Universiti Malaysia Perlis. It includes objectives, tools, and tasks for students to analyze and assemble pneumatic circuits. The lab aims to enhance students' understanding of designing and operating electro-pneumatic circuits.

Uploaded by

muhammad981120
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as DOC, PDF, TXT or read online on Scribd
You are on page 1/ 4

MDJ20303 PNEUMATIC AND HYDRAULIC SYSTEM

UNIVERSITI MALAYSIA
PERLIS
COURSE NAME PNEUMATIC AND HYDRAULIC SYSTEM
COURSE CODE MDJ20303 (M) LAB No. 5

LAB MODULE

BASIC ELECTRO PNEUMATIC

LEVEL OF COMPLEXITY
1 2 3 4 5 6
KNOWLED REPETITIO APPLICATI EVALUATI SYNTHESI
ANALYSIS
GE N ON ON SE
√ √ √ √ √

FACULTY OF MECHANICAL
ENGINEERING AND TECHNOLOGY

PREPARED BY: KHAIRUL FADZLY


Page 1 of 4
MDJ20303 PNEUMATIC AND HYDRAULIC SYSTEM

LAB-
05

UNIVERSITI MALAYSIA PERLIS


(UniMAP)

MAKMAL AUTOMASI DAN ROBOTIK-DIPLOMA


Revision: 00

(1) Kod kursus/ Course code: MDJ20303

(2) Tajuk kursus/ Course title: Makmal Sistem Pneumatik dan Hydraulic/ Pneumatic and
Hydraulic Systems Lab.

(3) Lab Topic : BASIC ELECTRO PNEUMATIC

BASIC ELECTRO PNEUMATIC

(4) Objective :

• To be able to design circuits using electro pneumatic.

(5) Introduction

PREPARED BY: KHAIRUL FADZLY


Page 2 of 4
MDJ20303 PNEUMATIC AND HYDRAULIC SYSTEM

(6) Tool

Project task

1. Analyze the pneumatic circuit diagram for the press-in device.


2. Carry out the assembly for circuit below (circuit A) and second circuit (circuit B) replace S2 with a
limit switch.
3. Check the assembled circuit for both circuits.
4. Describe the mode of operation of both circuits.
5. Compile an equipment list.

Circuit A

PREPARED BY: KHAIRUL FADZLY


Page 3 of 4
MDJ20303 PNEUMATIC AND HYDRAULIC SYSTEM

(9) Discussion
Describe what you have observe and understand in the experiment.

(10) Conclusion
Comment made based on the experiment objective.

PREPARED BY: KHAIRUL FADZLY


Page 4 of 4

You might also like