Network Analysis Assignments
Network Analysis Assignments
Assignment-1
1. Find the equivalent Resistance between terminals x-y in the resistive network.
3. Find the Current through the 5 ᾯ Resistor in the Figure using Norton’s Theorem.
4. Determine the Resistances in equivalent Star Network if the Resistances in Delta Connected
Network is known and Vice-versa.
Assignment-2
1. Determine the initial and final values for the function X(S) = 2(S+4) / (S+3)(S+8).
2. State and Prove Convolution Theorem for Laplace Transform. Determine the Convolution of
two signals x1(t) = e-3t , x2(t) = u(t) using convolution Theorem.
3. In a RC series circuit R=1Ω and C=0.5F. An exponential voltage v=10e -t is suddenly applied
at t=0. Obtain i (t). Assume no initial charge in the capacitor.
4. State and Prove any two Properties of Laplace transform.
5. A Series R-L circuit has R=25ohm and L= 5 Henry. A dc voltage of 100v is applied at t=0. Find
i) The equations for charging current, voltage across R and L
ii) The current in the circuit 0.5 second later and
iii) The time at which the drops across R and L are same.
Assignment-3
1. A current of 5A flows through a non – inductive resistance in series with a choking coil when
supplied at 250 V, 50 Hz. If the voltage across the non – inductive resistance is 125 V and across
the coil 200V, calculate the impedance, reactance and resistance of the coil, power absorbed by
the coil and the total power. Draw the phasor diagram.
2. A resistor of 50Ω, inductance of 100mH and a capacitance of 100µF are connected in series across
200V, 50Hz supply. Determine the following (i) Impedance (ii) current flowing through the circuit
(iii) power factor (iv) voltage across R,L &C (v) power in watts.
3. A parallel RLC circuit is supplied with a voltage source of 230 V, 50Hz. Determine circuit current
and power factor if R=40Ω, L=0.2H and C=50µF.
4. Explain the phasor relation for Parallel RLC Circuit.
5. Find the current ix in the circuit shown below by using nodal analysis.
Assignment-4
1. Obtain the relation between resonant frequency, bandwidth and Q-factor for Series R-L-C circuit.
2. A series RLC circuit has R=10Ω, L=0.5H and C=40µF. The applied voltage is 100V. Find (a)
Resonant frequency & Quality factor of a coil (b) Bandwidth (c) Upper and lower Half power
frequencies (d) Current at resonance & current at half power points (e) Voltage across inductance
& voltage across capacitance at resonance.
3. In a parallel resonance circuit (Tank circuit) R=2Ω, L=1mH and C=10µF, Find the Resonant
frequency, Dynamic impedance and Bandwidth.
4. What is coupling coefficient? Derive the expression for it.
5. Obtain a conductively coupled equivalent circuit for the magnetically coupled circuit shown
Figure Below.
Assignment-5