Communication Systems - Midterm Exam - Feb 2025
Communication Systems - Midterm Exam - Feb 2025
Question (2):
Noise in Communication systems can be divided into two types, what are they?
1-……………………………………………………………………………
2-……………………………………………………………………………
A 300 resistor is connected across 300 antenna input of TV receiver. The
bandwidth of receiver is 6 MHz, and temperature at room is (20 + 273) K. Find the
noise power and noise voltage applied to receiver input.
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………..
The signal power at input of amplifier is 100 W and power noise is 1W. At the
output, signal power is 1 W and noise power is 30 mW. What is the amplifier NF, as a
ratio?
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
……………………………….…………………………………………………………………
…………………………………………………………………………………………………
………………………………………
Find the modulation index if a 10 V carrier is modulated by three different frequencies
with amplitudes 1 V, 2 V, and 3 V, respectively.
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
………………….………………………………………………………………………………
……………………………………….
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
……………………………………..
Question (3):
For a Full-Carrier AM wave with carrier voltage Ec=10V, a load resistance RL=10,
and modulation coefficient m = 1, determine:
- Powers of carrier and upper and lower sidebands
- Total sideband power
- Total power of modulated wave
- Draw power spectrum
- Repeat solution for m = 0.5 and compare.
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
………………………………..
An additional 2 kHz signal modulates the carrier with m = 0.2.
Sketch (Draw) the voltage spectrum
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
…………………………………………………………………………………………………
………………………………..
@&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&&@