0% found this document useful (0 votes)
13 views3 pages

Sheet 3

Uploaded by

salma180lotfy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
0% found this document useful (0 votes)
13 views3 pages

Sheet 3

Uploaded by

salma180lotfy
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Sheet 3

Q1. Chose the correct answer:


1. If a transistor with a higher βDC is used in Figure,
the collector current will
(a) increase (b) decrease (c) not
change
2. If a transistor with a higher βDC is used in Figure,
the emitter current will
(a) increase (b) decrease (c) not
change
3. If a transistor with a higher βDC is used in Figure,
the base current will
(a) increase (b) decrease (c) not
change
4.If VBB is reduced in Figure, the collector current
will
(a) increase (b) decrease (c) not
change
5. If VCC in Figure is increased, the base current will
(a) increase (b) decrease (c) not
change

6. If the amplitude of Vin in Figure is decreased, the


ac output voltage amplitude will
(a) increase (b) decrease (c) not
change

7. If the transistor in Figure is saturated and the base


current is increased, the collector current will
(a)Increase (b) decrease (c) not change
8. If RC in Figure is reduced in value, the value of
IC(sat) will
(a)Increase (b) decrease (c) not change
9. If the transistor in Figure is open from collector to
emitter, the voltage across RC will
(a)Increase (b) decrease (c) not change
10. If the transistor in Figure is open from collector
to emitter, the collector voltage will
(a)Increase (b) decrease (c) not change
11. If the base resistor in Figure is open, the transistor
collector voltage will
(a)Increase (b) decrease (c) not change
12. If the emitter in Figure becomes disconnected
from ground, the collector voltage will
(a)Increase (b) decrease (c) not change

BJT Characteristics and Parameters


1. A base current of 50 mA is applied to the transistor in Figure, and a voltage of 5 V is
dropped across RC. Determine the βDC of the transistor

2. Calculate αDC for the transistor in Problem6.


3. Assume that the transistor in the circuit, Determine IB, IC, IE, and βdc
4. Find VCE, VBE, and VCB in both circuits of Figure?

5. Determine whether or not the transistors in problem 8 . are saturated


6. Find IB, IE, and IC in Figure. αDC=0.98.

7. Determine the terminal voltages of each transistor with respect to ground


for each circuit in Figure . Also determine VCE, VBE, and VCB.

You might also like