Scribd
Upload
11 views1 page

1DR TCP Normal

This document provides a wiring diagram for a single door TCP/IP reader, detailing connections for power, data, and various components. It includes information on IP address configuration, RJ45 connector color codes, and relay settings for door control. Important notes on installation and wiring precautions are also included.

Uploaded by

thohe0711
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
11 views1 page

1DR TCP Normal

This document provides a wiring diagram for a single door TCP/IP reader, detailing connections for power, data, and various components. It includes information on IP address configuration, RJ45 connector color codes, and relay settings for door control. Important notes on installation and wiring precautions are also included.

Uploaded by

thohe0711
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

ATTN: THIS IS FOR AY-HO20

READER ONLY SINGLE DOOR TCP/IP WIRING DIAGRAM


IP ADDRRESS
+12V----- RED CTRL -1DRSMT-TCP/IP(1.5A)-PCB
0V ------BLACK
D1-----WHITE The default IP address should
D0-----GREEN be showed on a warranty
GLED----ORANGE (AY-H020) sticker with a square onto the
GLED-----BROWN (RD-J12) numbers. Example:
TAMPER-----PURPLE IN READER OUT READER
BUZZ-----YELLOW XXXXX
GLED Then the IP for the door
RJ45 CONNECTOR COLOUR CODE
controller would be
DIRECT CABLE CROSS CABLE 192.168.1.XX
TMP BUZ
1 White Orange White Green FALCO FALCO

12V
2 Orange Green
12V

0V
D1
D0
3 White Green White Orange GLED
0V

4 Blue Blue
D1
D0
5 White Blue White Blue
6 Green Orange MAGNETIC CONTACT
7 White Brown White Brown
8 Brown Brown NO

COM
PUSH BUTTON
12V
0V
D1 IN
D0 IN
D1 OUT
D0 OUT
L1
BZ
TP
DS
PB
L2
IN1
IN2
0V

To RJ -45 Expansion for


Network 2nd Door

EM-LOCK
FA-102 NORMAL /
Emergency Break Glass RESET
JP1
COM
NO

NC/NO
NC

Expansion for I/O


JP6
Module
3A 2A 1A C2
- + O2
C1
O1
NO/NC

0V JP5
AC
12V
AC1
JP4 14VAC 230 VAC
JP3
JP2
1 2 3 4 5 6 7 8
+ -

TAMPER RELAY SETTING Battery


OFF ON closed- power / open- dry
contact
KS - 28 Key Switch DOOR 01 JP2 is for relay 2 (CRY2)
KS - 20 JP3 is for relay 1 (CRY1)
EM-LOCK / STRIKER USAGE
JP5 select NO/NC for relay 1
JP6 select NO/NC for relay 2
# For Best Result
Important Note:
Please solder the wire tip before termination
# DS and 0V must be short if door sensor is not installed.
Please do not connect reader unshielded cable and reader any cable to earth. By Sim 19-04-2006

You might also like