Scribd
Upload
5 views3 pages

Nsa 5

The document outlines a worksheet for a network system administration assignment focused on configuring IPv4 subnetting using Cisco Packet Tracer. It details the required components, implementation steps for connecting devices, and an IP addressing scheme for two subnets. The learning outcomes include subnetting a network, configuring inter-subnet communication, and testing connectivity with ping commands.

Uploaded by

Keshav Gangwar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
5 views3 pages

Nsa 5

The document outlines a worksheet for a network system administration assignment focused on configuring IPv4 subnetting using Cisco Packet Tracer. It details the required components, implementation steps for connecting devices, and an IP addressing scheme for two subnets. The learning outcomes include subnetting a network, configuring inter-subnet communication, and testing connectivity with ping commands.

Uploaded by

Keshav Gangwar
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 3

Worksheet - 5

Student Name: Keshav Kumar UID 23MCA20462


Branch: MCA Section/Group: MCA-8A
Semester: 4th DOP: 25-Feb-2025
Subject Name: NETWORK SYSTEM ADMINISTRATION Subject Code: 23CAH-753

AIM: - To configure IPv4 subnetting in Cisco Packet Tracer using 1 router, 2 switches, and 6 PCs.

Required Components:-

• 1 Cisco 2911 Routers


• 2 Cisco 2960 Switches
• 6 PCs
• Straight-through Ethernet cables
• Packet Tracer software

Implementation Steps
Step 1: Add Devices and Connect Them
1. Open Cisco Packet Tracer using one 2911 routers and drag two 2960 switches into the
workspace.
2. Add six PCs and name them PC0 to PC5.
3. Use Ethernet cables to connect:
· Router (GigabitEthernet0/0) → Switch1
· Router (GigabitEthernet0/1) → Switch2
· PC0, PC1, PC2 → Switch1
· PC3, PC4, PC5 → Switch2
· Switch1 and Switch2 via trunk link

Step 2: IP Addressing Scheme:

1. Given Network: 192.168.10.1/25


2. Subnet Mask Used: 255.255.255.128 (/25)
3. Subnetting Calculation:
1. Subnet 1 (Switch1 & PCs 0-2): 192.168.10.4/25
2. Subnet 2 (Switch2 & PCs 3-5): 192.168.10.132/25
3. Usable IPs per Subnet: 30
4. Subnet Gateway (Router IPs):
1. For Switch1: 192.168.10.1
2. For Switch2: 192.168.10.129
IPv4 Subnetting mask using pc0 and pc3:-

Packet tracer: -
Pinging: -

Note: - we can ping for all the PCs as the same process

Learning Outcomes:-
⚫ Subnetted a network using IPv4 /25 subnet mask.
⚫ Configured a router for inter-subnet communication.
⚫ Assigned IP addresses correctly to PCs and switches.
⚫ Tested network connectivity using ping commands.

Sign……………

You might also like