Scribd
Upload
34 views1 page

CAED

The document outlines an examination paper for a Mechanical Engineering course at BMS College of Engineering, focusing on Computer-Aided Engineering Design (CAED). It includes instructions for answering questions from two parts, with specific tasks related to drawing projections of points and lines in relation to horizontal and vertical planes. The questions involve geometric constructions and projections based on given dimensions and angles.

Uploaded by

RajaRajan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
34 views1 page

CAED

The document outlines an examination paper for a Mechanical Engineering course at BMS College of Engineering, focusing on Computer-Aided Engineering Design (CAED). It includes instructions for answering questions from two parts, with specific tasks related to drawing projections of points and lines in relation to horizontal and vertical planes. The questions involve geometric constructions and projections based on given dimensions and angles.

Uploaded by

RajaRajan
Copyright
© © All Rights Reserved
We take content rights seriously. If you suspect this is your content, claim it here.
Available Formats
Download as PDF, TXT or read online on Scribd
You are on page 1/ 1

BMS COLLEGEOF ENGINEERIN ANGALORE-19

(Autonomous Intituie A6
Departnent of Mechanical Engineering
SemesterSection:
CIE-I FAculty:
11PO
Coune Code :22MEZESCED Coune Title :CAED
Masimum Marks: 40 Date: 20 072023 Timlngs:2 00 AM-) 15 PM
Instructinns: Answer one complete questinn from PartA and Part
PART A

a) Draw the projections ofa point lying 40 mm above HP and is in the first quadrant
when its shortest distance from the line of intersection of |P and VP is 50 mm.

Mark the distance of the point from VP


b) The midpoint of a line AB is 60 mm above |P and 50 mm in front of VP. The
line measures 8Omm and is inclined at 35° to HP and 40 to VP. Draw its
projections.
OR

2)
in
a) Draw the three principal views of a point P Iying 65 mm below HP, 70 mm
5
front of VP, and 50 mm in front of the right protile plane.
measurcs 70
b) A line AB is 90 mm long. It is inclined at 45° to HP. Its front view
of VP. The end B is
mm. The end A is 15 mm above HP and 25 mm in front
(i) its
higher than the end A. Draw the projections of the line AB. Mark:
15
inclination with VP and (ii) the length of its top view.
PART B
on HP on one of its sides while its opposite
3) A regular pentagon of 30 mm sides is resting
side in HP is inclincd at 30
vertex (corner) is 30 mm above HP. Draw projections when
2)
inclined to VP.

HP on onc of its shorter cdges. The


4) A 35 mm x 20 mm rectangular lamina rests on
makes an angle of 55 with HP
lamina is rotated about the edge on which it rests till it
its projcctions. 20
The cdge on which the lamina rests is inclined at 30° to VP. Draw

You might also like