DPP Unit and Measurement, Motion in A Straight Line, Motion in A
DPP Unit and Measurement, Motion in A Straight Line, Motion in A
VIDYAPEETH
DPP_Test Discussion
Unit and Measurement, Motion in a straight line, Motion in a plane,
Law's of Motion, Friction, Work, Energy and Power,
System of particles and Rotational motion.
1. If gravitational constant (G) and Planck’s constant 8 + 10sin
(A) tan =
(h) and the velocity of light (c) be chosen as 10cos
fundamental units then the dimensions of the radius
8 + 10sin
of gyration is : (B) tan =
(A) h1/2 c–3/2G1/2 (B) h1/2c3/2G1/2 10cos
1/2 –3/2 –1/2
(C) h c G (D) h–1/2 c–3/2G1/2 (C) tan = tan
(D) tan = cot
2. Intensity observed in an interference pattern is I =
I0sin2. At = 30° intensity I = 5 ± 0.0020 W/m2. 5. Two particles A and B separated by a distance 2R
Find percentage error in angle if I0 = 20 W/m2. are moving counter clockwise along the same
4 2 circular path of radius R each the uniform speed v.
(A) 3 10−2% (B) 3 10−2% At time t = 0, A is given a tangential acceleration of
1 3 77v2
(C) 3 10−2% (D) 3 10−2% magnitude a =
25R
. Then
(A) the time lapse for the two bodies to collide is
3. Students I, II and III perform an experiment for 6R
measuring the acceleration due to gravity (g) using a 5v
simple pendulum. They use different lengths of the (B) the angle covered by A is 11/6
pendulum and/or record time for different number of 11v
oscillations. The observations are shown in the (C) the angular velocity of A is
5R
table. (D) the radial acceleration of A is 289v2/5R
Studen Lenth of No. of Total time Time
t the oscillation for (n) perio 6. For an observer on trolley direction of projection of
pendulu s (n) oscillation d (s) particle is shown in the figure, while for observer on
m (cm) s ground ball rise vertically. The maximum height
I 64.0 8 128.0 16.0 reached by ball from trolley is
II 64.0 4 64.0 16.0
III 20.0 4 36.0 9.0
If EI, EII and EIII are the percentage errors in g, i.e.,
g
100 for students I, II and III, respectively,
g
then:
(A) EI = 0 (B) EI is minimum
(C) EI = EII (D) EII is maximum (A) 10 m (B) 15 m
(C) 20 m (D) 5 m
4. Rain, pouring down at an angle with the vertical
has a speed of 10 ms–1. A girl runs against the rain 7. A block of mass m is placed on a surface with a
with a speed of 8 ms–1 and sees that the rain makes x3
vertical cross section given by y = . If the
an angle with the vertical, then relation between 6
and is: coefficient of friction is 0.5, the maximum height
above the ground at which the block can be placed
without slipping is:
2
velocity of rod when it makes an angle of 37° with 11. A particle falls from a height h on a fixed horizontal
the vertical is: plane and rebounds. If e is the coefficient of
restitution, the total distance travelled by the particle
before it stops rebounding is:
h[1 − e2 ] h[1 − e2 ]
(A) (B)
2[1 + e2 ] [1 + e2 ]
h[1 + e2 ] h[1 + e2 ]
(C) (D)
2[1 − e2 ] [1 − e2 ]
uses dimensions and assumes that the distance After 1 s explosion takes place and the particle is
depends on the mass density r of the fog, intensity broken into two equal pieces.
(power/area) S of the light from the signal and its As a result of explosion one part comes to rest. If
frequency f. The engineer finds that d is proportional
the maximum height attained by the other part is 5x
to S1/n. The value of n is
then x will be. (take g = 10 m/s2)
25. A block slides down a smooth inclined plane to the
ground when released from the top, in time t 28. An object is dropped from a height h from the
seconds. Another block is dropped vertically from ground. Every time it hits the ground it looses 50%
the same point, in the absence of the inclined plane of its kinetic energy. The total distance covered as
and reaches the ground in t/2 second. Then find the t → is how much times of h?
angle (in degree in multiple of 10) of inclination of
the plane with the vertical. 29. A particle of mass 0.2 kg is moving in one
dimension under a force that delivers a constant
26. A uniform disc of mass m and radius R is pivoted at power 0.5 W to the particle. If the initial speed of
point P and is free to rotate in vertical plane. The the particle is zero, the speed (in ms–1) after 5 s is
centre C of disc is initially in horizontal position
with P as shown in figure. If it is released from this 30. A circular plate of uniform thickness has a diameter
position, then its angular acceleration when the line of 56 cm. A circular portion of diameter 42 cm is
PC is inclined to the horizontal at an angle is removed from one edge of the plate as shown. At
what distance (in cm) to the left from the centre of
2 g cos
, then x will be the disc is the centre of mass of the remaining
xR portion ?